JY-710RX………………………………………5 Inserting Batteries………………………………5 Replacing Batteries……………………………5 When the JY-710 is Not in use………………5 Lighting/Lock Button…………………………6 Connecting the JY-710… … … … … … … … … … 6 Using the JY-710…………………………………7 Timed Photography………………………………7 Manual Release…………………………………14 Precautions for use………………………………15 Caring for the JY-710……………………………15 Specifications…...
(1/2) Peringatan Keep out of reach from children Do not disassamble or modify To prevent damage to your product or injury to yourself or to others,read the following sa- Failure to observe this precaution could re- This device contains small parts which may fety precautions in their entirety before using sult in electric or product malfunction.
Page 5
(2/2) Peringatan Read precaution label when in use Batteries may leak or explode if improperly han- dled.Observe the following precautions when hand- ing batteries for use in this device: Use only batteries listed in this manual. Do not mix old and new batteries or batteries of different types.
Bagian Produk (1/3) Pengenalan Please see the back of the cover Thank you for your purchase JY-710 wireless remote controller. The JY-710 is composed illustrations. by one JY-710TX( transmitter) and one JY-710RX(receiver) is equipped with an interval timer suited to wide variety of tasks, including astronomical photography.
When the JY-710 is not in use *The illustration inside the front cover shows the control panel with all elements lit. In the The JY-710 is not equipped with an off switch. other illustrations throughout this manual, To reduce the drain on the batteries when the...
TIMER ACTIVE RELEASE and “ ” ( ) indicators are not displ- (not flashing) ; if botton is in position, ayed,turn the camere off and disconnect the release shutter-release lock). JY-710. Replace the Remote cord socket te- rminal cover.
Timed Photography (1/7) 1. Adjust camera settings 2. Set the timers The JY-710 functions as: An automatic timer Choose the delay (ti- Connect the JY-710 and turn the camera Press the button ( )." " will me before shooting starts), exposure flash in the display panel.
Page 10
Timed Photography (2/7) Adjust the following settings: Option Description Supported settings DELAY Delay before shutter is released 0 s to 99 hrs 59 min 59s (in one-second increments) Exposure time LONG INTVL 1 s to 99 hrs 59 min 59s (in one-second increments) Interval Number of shots 1 to 399, --(unlimited)
Page 11
Timed Photography (3/7) Setting the timer Use the arrow button to set the timer. press left or right to select, Delay(time until shooting starts) up or down to change. The curr- ent selection is indicated by the Hour Minute Second Adjust selection cursor( settings...
Page 12
Timed Photography (4/7) Exposure time Interval Number of shots Speaker Minute Second Hour Minute Second...
Page 13
Timed Photography (5/7) 3. Set the timer Setting the timer After adjusting all settings as desired, TIMER START/STOP press the button ( ) to put the new Press the button ( To ensure correct operation, choose an int- settings into effect. Timer will issue a beep- TIMER ACTIVE The timer will start and “...
Page 14
Timed Photography (6/7) 4. End Shooting Show panel Display (Timer Active) Shooting will end automatically when the When that did not open the shutter: selected number of shots has been taken. shots: Time remaining until next shot To end shooting before all photographs have TIMER START/STOP been taken, Press the While shutter is open:...
Page 15
Camera (continuous- servo autofocus)* or (manual) (single frame) JY-710 Longer than camera shutter speed** * Select “release priority” if available. ** When using autofocus, choose an interval at least two seconds longer than the camera shutter speed to allow the camera time to focus. When using long exposure noise reduction (available with some digital cameras), choose an interval at least double the camera shutter speed.
Slide it in the opposite direction to beep will sound. 1. Adjust Camera Settings release the lock. Connect the JY-710 (pg.6) and turn the The shutter-release button can be used to camera on. Choose exposure mode, shutter release the shutter manually while the speed, focus mode, and shooting mode as timer is active.
This product is not waterproof and JY-710 (see the camera manual for details). Keep dry: the device may stop functioning. In most may malfunction if immersed in water or ex-...
Spesi kasi Nikon、Canon、Sony、Samsung、Pentax、Olympus、Konica、Minolta etc. Supported cameras 0s to 99hrs 59min 59s in one-second increments Timer delay 0s to 99hrs 59min 59s in one-second increments Exposure time Interval 1s to 99hrs 59min 59s in one-second increments Number of shots 1 to 399,-- (unlimited) Power source JY-710TX: AAA 1.5V LR03 battery×...
Need help?
Do you have a question about the JY-710 and is the answer not in the manual?
Questions and answers
My intervalometer will only let me set a delay (which I don’t need) and not the length of the shot or the interval needed between shots. Help, please.