Page 2
If you are in need of warranty service, contact your local dis- tributor or StainOut System. If the tool must be returned to StainOut System or an authorized service center, the pur- chaser will be responsible for all shipping charges for the products returned for warranty service.
Safety Information Do not operate the Penguin Cordless Sprayer if: • You are not properly trained and authorized. • If this unit is not in its proper operating condition. • If you and the unit are in standing water. • If you and the unit are in flammable or explosive areas. •...
Overview Penguin Sprayer Features Spray gun Tank handle Tank lid 5 gallon tank 8” wheels Storage bin Handle Coiled hose Charging cord socket Charging status light Hose connection Power light Power switch Package Includes: • Penguin Sprayer • Charging cord •...
Before Operation Adjust Handle Height Take off the handle by removing knurled thumb screws. Raise handle to next set of drilled holes. Place thumb screws and hand tighten. Connect the Hose and Spray Gun Connect the female quick disconnect fitting from the hose to the male fitting on the bottom of the spray gun.
Charging the Battery First time use - it is important to charge the Penguin Cordless Sprayer prior to operating the unit. The internal battery charger is a “SMART” charger. It will charge/recharge the battery without over-charging. Plug in the electrical cord to a standard 120-VAC grounded outlet.
Operation Fill the Tank Unscrew the tank lid and fill with up to 5 gallons of water or your preferred cleaning/ deodorizing/disinfecting chemical or solution. Turn the power switch to the ON position. You will hear the pump begin to run, as the pump pressure builds up and fills the hose, it will stop.
Empty the unit at the end of each job, and make sure the tank is cleaned out thoroughly. Flush the unit with clean water. If mineral deposits are a problem, flush unit using Clear Lines weekly rinse by StainOut System. It is important that the tank and pump are clear of any chemical solution for any period of time that the Penguin Cordless Sprayer is idle.
Changing Chemical If you need to change from one chemical to another, you will need to ensure the previous chemical is completely flushed from the system before filling with the new chemical. Empty the previous chemical from the tank. Pull out the dip hose from inside the tank. Insert the dip hose into an external container with clean warm water.
Need help?
Do you have a question about the SOS PRO Series and is the answer not in the manual?
Questions and answers