Related Manuals for Magna Systems ThermoSpyder
Summary of Contents for Magna Systems ThermoSpyder
- Page 1 Quick Start Guide ThermoSpyder Wireless 8-Channel Thermocouple Monitor Copyright 2008 by Magna Systems, L.L.C. Revision 0.2 (03/2009)
- Page 2 [ This page intentionally left blank ] Rev. 0.2...
- Page 3 4. Battery life depends on the data sampling period. Longer times between data samples will extend battery life. 5. Initialize data communication between the ThermoSpyder and the GateWay™ while they are within 15 feet of each other before starting a test. Once DataLink™ starts displaying real time data from ThermoSpyder, position ThermoSpyder at the desired start location.
- Page 4 Installation Procedure for DataLink Software Step 1. Check your system requirement at Control Panel/System/General for Window XP Service Pack 2 or later version Call Customer Service to request the special DataLink version for Windo ws VISTA. Excel Application/Help/About Microsoft Excel for Microsoft Excel 2002 or later version Step 2.
- Page 5 Step 5. A window [Found New Hardware Wizard] appears. Select [No, not this time] Step 6. Select [Install the software automatically] Rev. 0.2...
- Page 6 Step 7. Window operating system shall locate [USBXpress Device] automatically. Step 8. USB driver shall now be Installed successfully. Rev. 0.2...
- Page 7 DataLink Data-logger Starter Guide Step 1. In the [Data Display] window, select [Data Logger]. Step 2. If an existing test configuration file exists, select [Repeat an existing test]. Otherwise, select [Start a new test]. Step 3. Position the module* near GateWay such that there is a direct radio communication path. Step 4.
- Page 8 *Note 1. Module can be a ThermoSpyder, a ThermoSpyder, or other radio-communication products from Magna Systems. 2. The data count in the test report does not start from count number 0. The starting count number depends on when the module is switched to a data -logger mode.
- Page 9 Diagnosis Procedure for Module Communication Step 1. Verify the battery voltage to be at least 1.3 volts each. Step2. Verify the battery installation orientation is correct. Wrong installation orientation will cause damage on the module. Step 3. Make sure that no other module is powered by batteries except the target module, i.e. S/N 1234.
- Page 10 Step 17. The resistance value shall be greater than 1000 Ohms. Otherwise, it indicates that the power circuitry is damaged due to wrong battery installation. Step 18. Send the module S/N 1234 back to Magna Systems for an evaluation. End of Document...
Need help?
Do you have a question about the ThermoSpyder and is the answer not in the manual?
Questions and answers