SV STRC-600 Quick Start

Security VIP
Global Technology

Activation the transmitter.

Connect the power supply (6 - 14VDC) to the transmitter.
The green LED on the PCB of STRC-600 must shine during short time.
For getting of the best quality of a sound it is recommended to use Tone control in
STV-02.
/Press [F] [4] for treble control. [UP]/[DOWN] – to select treble level. [F] – to accept selection.
[CALL] – to cancel.
Press [F] [5] for bass control. [UP]/[DOWN] – to select bass level. [F] – to accept selection. [CALL] –
to cancel./

Deactivation the transmitter.

Disable the power supply.

Changing operating frequency

Enter a frequency, following preceding sections "Entering a frequency" and
"Changing frequency, using [UP] [DOWN]
RECEIVER Quick start".
The frequency range of STRC-600 is limited within the limits of from 400.000
MHz up to 440.000 MHz !

Transmitting new operating frequency to the STRC-600

1. Connect the power supply (6 - 14VDC) to the transmitter.
2. Press and hold down for 1 sec. the
number starts blinking.
3. Place antenna of STV-02 in immediate proximity from STRC-600.
4. Press the [Transmitter ON]
STRC-600 during 6 sec. The green color of the "TX/BAT" lamp indicates
the transmitting. The green LED on the PCB of STRC-600 must shine
during short time.
[CALL] – to cancel setting-up procedures (if Step 4 was not performed the
transmitter STRC-600 will not be reprogrammed).
http://www.s-vip.com
STRC-600 Quick Start
key" from "STV-02 COMBO
[REV] key. The memory channel
key. The control word is transmitted to the
Security VIP
Global Technology
4 of 4 http://www.s-vip.com
STRC-600 ANALOG MINITRANSMITTER
Quick start
STRC-600 Quick Start
1 of 4