Page 1
CRC100R Controller. For detailed CRC100R user information, refer to the User Guide. Fitting the CRC100R The CRC100R is supplied on a mounting bracket for fixing into a suitable enclosure via four fixing holes. Use 4 x M4 screws to secure the controller to a back plate.
Page 2
CRC100R Quick Installation Guide ISSUE 03 Basic Confidence Check Once all cables have been terminated, power up the CRC100R and check that the opening screen is displayed as follows: C R C 1 0 0 R V e r : 2 . x x Also check that the connected reader has the correct ready status displayed (refer to the anufacturer’s handbook).
Page 3
See explanation below) below. Standard Nortech Clock & Data (Mag) Card Format Settings If the CRC100R is to be used with standard cards that have been supplied by Nortech, the card format settings should be: Format: MAG Digits: 10 Len: 8 Offset: 02 Note: No site code is necessary as all digits are used as the card number.
Page 4
CRC100R Quick Installation Guide ISSUE 03 Note 1: In W26 mode, there is a n option to set the site code and add the cards by card number only. If required , add the site code before continuing with the sequence.