Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lipper Ground Control 3.0
Summary of Contents for Lipper Ground Control 3.0
- Page 1 Ground Control ® 5th Wheel Leveling Prepped Kit OEM INSTALLATION MANUAL...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction Safety Resources Required Installation of Prep Kit Switch Panel Installation Wiring the Switch Panel and Landing Gear Rear Sensor Harness Middle and Rear Jack Harnesses Operation Prior to Operation Operating Landing Gear Troubleshooting Manual Override Wiring Diagram Notes Introduction The Ground Control®... -
Page 3: Resources Required
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury and/or product or property damage if not safely adhered to and within the parameters set forth in this manual. Always wear eye protection when performing service, maintenance or installation procedures. - Page 4 Feed the two landing gear harnesses ends (Fig. 2A) through compartment hole and attach to the appropriate switch panel (Fig. 2B) harness receptors, see Wiring the Switch Panel and Landing Gear and Wiring Diagram sections for complete wiring instructions. Fig. 2 Compartment Wall Place the switch panel plate (Fig.
-
Page 5: Wiring The Switch Panel And Landing Gear
Wiring the Switch Panel and Landing Gear NOTE: Circuit protection is not supplied. LCI recommends a 30 amp auto-reset circuit breaker for this system and prep a 50 amp circuit breaker, placed in line with the power source for the future upgrade installation. -
Page 6: Rear Sensor Harness
Rear Sensor Harness In the same compartment as the switch panel, create a separate hole that will allow access to the inside chassis area or use any gap in the compartment walls. NOTE: Allow ample harness excess at both ends to ensure room for future installation connection to the controller and sensor. -
Page 7: Operation
Operation Never attempt to operate the system without the footpad properly secured or severe product damage, serious personal injury or death may occur. Electric landing gear is designed for vertical operation. Excessive side loads may cause damage to the landing gear. The bolt-on pull pin MUST be inserted fully through both sides of the tube prior to use. -
Page 8: Troubleshooting
Troubleshooting What is happening? Why? What should be done? Inner legs were Connect to tow vehicle, retract jacks, extend Unable to level trailer. extended while trailer inner leg making sure to allow room to level was above level. trailer once tow vehicle is removed Test battery voltage under load. - Page 9 Bottom of Jack Motor Override: 5/16 Tools needed: ” drive ratchet and extension, ” socket Find the port on the bottom of the jack motor (Fig. 15A). Remove the rubber plug (Fig. 16A). 5/16 Insert the ” socket into the port (Fig. 17). Turn override until the jack extends or retracts to desired position.
-
Page 10: Wiring Diagram
Wiring Diagram Landing Gear 2 Wire Harness Connections Passenger Side Driver's Side Landing Gear Landing Gear Landing Gear Connection Landing Gear Connection for Future Leveling Installation for Future Leveling Installation (not used at this time) (not used at this time) Landing Landing Gear Harness... -
Page 11: Notes
Notes Page 11 Rev: 09.02.21 CCD-0004395... - Page 12 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (LCI). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. The information contained in this manual is subject to change without notice and at the sole discretion of LCI. ...
Need help?
Do you have a question about the Ground Control 3.0 and is the answer not in the manual?
Questions and answers