Advertisement
Configure eth0 from the NETWORK
CONFIGURATION screen
Configure the Ethernet 0 (eth0) network interface
card (NIC) at the NETWORK CONFIGURATION
screen:
1. At the setup menu (Figure 4 on page 4), use the
key to move the cursor to Network
TAB
Configuration.
2. Press
. The NETWORK
ENTER
CONFIGURATION screen displays (Figure 6).
Note:
The bottom of the NETWORK
CONFIGURATION screen shows the navigation
commands. The most commonly used commands
are
, +, and ^
(
TAB
Q
simultaneously). The ^
steps the display back through the program.
3. Use the
key to move the cursor to eth0.
TAB
4. Use the
key to move the cursor to the IP
TAB
Address field in the IP Configuration column.
Figure 6: Sample NETWORK CONFIGURATION screen for eth0
key and
key pressed
CTRL
Q
(return) command
Q
5. Type the IP address that you received from the
network administrator.
6. Press the
key to move the cursor to the
TAB
Network field in the IP Configuration column.
7. Type the same address that you entered in the
IP Address field, but substitute a 0 for the last
number.
8. Press the
key to move the cursor to the
TAB
Network Mask field in the IP Configuration
column.
9. Type the subnet mask address that you received
from the network administrator.
10. Press the
key to move the cursor to the
TAB
Broadcast field in the IP Configuration column.
11. Type the same address that you entered in the
IP Address field, but substitute 255 for the last
number.
12. Use the ^
command to return to the setup
Q
menu (Figure 4 on page 4).
13. Go to Configure eth1 from the NETWORK
CONFIGURATION screen on page 6.
5
3270 3319 Rev B
Advertisement
