Matrix Audio Element Series Quick Start Manual

Matrix Audio Element Series Quick Start Manual

Wi-fi connection

Advertisement

Wi-Fi Connection Issues Guide

Q: Element X/P/M cannot enter Wi-Fi Connection Mode.
A: - Please check whether the voltage switch is set to the correct position. If the input voltage
is too low, the device will not work properly. If the input voltage is much higher than the
voltage set on the unit, the device may be damaged.
- Please check if the "Network Type" option in the settings menu is set to "Wi-Fi".
- Be sure to press the knob for more than 5 seconds to enter Wi-Fi Connection Mode.
Q: The device cannot connect to the wireless network.
A: - Please check if the "Network Type" option in the settings menu is set to "Wi-Fi".
- Please confirm that the access password of the wireless network is correct and try again.
- Please check the signal strength of the wireless network where the device is located.
Please place the device as close as possible to the Wi-Fi router or reduce wall blocking.
Q: When configuring the wireless connection, the element device has connected to
the network successfully, but the MA Remote app shows that the device was not
found.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Element Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Matrix Audio Element Series

  • Page 1 Wi-Fi Connection Issues Guide Q: Element X/P/M cannot enter Wi-Fi Connection Mode. A: - Please check whether the voltage switch is set to the correct position. If the input voltage is too low, the device will not work properly. If the input voltage is much higher than the voltage set on the unit, the device may be damaged.
  • Page 2 A: - Re-enter Add Device Wizard in MA Remote, select "Add Device Automatically", wait for the scan results and add the device. - Check the IP address in settings menu of element device, select "Add Device Manually" in Add Device Wizard in MA Remote and enter the IP address.
  • Page 3 Q: Device cannot be added to MA Remote manually. A: Make sure that the element device is connected to the LAN over Wi-Fi or a network cable. After the network is successfully connected, the corresponding network status icon will light up in the upper left corner of the screen, then enter the settings menu and scroll to the "Product Info"...

Table of Contents