Powerboost - Siemens EX8-LX Series User Manual

Flexinduction hob with integrated ventilation system
Hide thumbs Also See for EX8-LX Series:
Table of Contents

Advertisement

en Operating modes
Sensor
Function
​ ⁠
fryingSensor
​ ⁠
Switch-off timer / Timer
​ ⁠
countUp function
​ ⁠
Wi-Fi
​ ⁠
Sensor ventilation control
​ ⁠
Ventilation control
Depending on the status of the hob, the displays for
the cooking zones and the various activated and avail-
able functions also light up.
5.5 Distribution of the cooking zones
The specified power has been measured with the
standard pots, which are described in IEC/EN
60335-2-6. The power may vary depending on the size
of the cookware or cookware material.
A
6  Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
6.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).
¡ If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.
¡ If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.
8
A
Area
Highest power level
​ ⁠ ​ ⁠ ​ ⁠ ​ ⁠
Power level 9

powerBoost

​ ⁠ ​ ⁠
Power level 9
powerBoost
5.6 Cooking zone
Before you start cooking, check whether the size of the
cookware fits the cooking zone that you want to use for
cooking:
Area
Cooking zone type
​ ⁠
Single-circuit cooking zone
​ ⁠
Flex Zone
→ "flexInduction", Page 12
5.7 Residual heat indicator
The hob has a residual heat indicator for each cooking
zone. Do not touch the cooking zone if the residual
heat indicator is lit.
Display
Meaning
​ ⁠
The cooking zone is hot.
​ ⁠
The cooking zone is warm.
6.2 Air recirculation mode
The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.
To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.
2200 W
3700 W
3300 W
3700 W

Advertisement

Table of Contents
loading

Table of Contents