Connections; Speaker Connections - Koss KS3101A-2 Instruction Manual

(3) Speaker connections

Before Connecting
This DVD Receiver is designed to reproduce optimum sound quality when the supplied speakers are used. If you
wish to connect other speakers to the system instead of the supplied speakers, they should be 6 ohms
impedance with a minimum power handling of 50 watts each.
Maintain correct polarity when connecting speakers (colored wire for positive and black wire for negative).
To prevent damage to circuits, never short-circuit the positive and negative speaker output terminals.
Connection
The above connections can be expressed by the below table:
SPEAKERS FRONT LEFT FRONT RIGHT
Unit
L+
L -
Terminals
White Black
Use Wires
Speakers
White
Black
Terminals
Press the button down & insert the wire, then release the button.
Connection of all speakers are the same.
CENTER
R+ R - C+
Red Black Green
Red Black Green Black
Note: always connect colored wire to colored speaker terminal (+).
always connect black wire to black speaker terminal (-).
SURROUND
LEFT (REAR) RIGHT (REAR)
C - SL+ SL -
Black Blue Black
Blue
Black
SURROUND
PASSIVE
SUBWOOFER
SR+ SR - +
Grey Black
Purple
Grey Black
Purple
Notes
• Do not remove
excessive amount of
insulation on the wire
cords, to avoid the
stripped portion from
touching each other. The
optimal length for the
stripped part should be
around 1/3 inch (or
1cm).
• Do not push the
stripped part too far
into the speaker
connectors.
-
Black
Black
E 11