Table of Contents
Advertisement
Available languages
Available languages
Operating Instructions Pre-Start Up
General Safety
1.
Before operating this machine, read and observe all safety, unpacking, and
operating instructions. Failure to comply with these instructions could create a
hazardous situation.
2.
The operator of this equipment should not operate this equipment when fatigued
or under influence of alcohol or drugs.
3.
The operator of this equipment should be thoroughly familiar with its operation
and trained in the job to be accomplished.
4.
The operator of this equipment should wear protective face shields and other
protective clothing as required for safe operations.
5.
Do not leave this machine unattended when it is operating.
6.
All installations must conform to all applicable local codes. Contact your
electrician, plumber, utility company or seller for details.
7.
Follow instructions on how to stop the machine and bleed pressures quickly. Be
thoroughly familiar with the controls.
8.
Do not operate the machine if any mechanical failure is noted or suspected.
9.
When starting a job, survey the area for possible hazards and correct before
proceeding.
10. Keep all protective covers and shields in place. Operating this machine with
moving parts could allow operator or bystander serious injury or even death.
Replace all protective covers and shields after adjustments are made to prevent
accidental contact with hazardous parts.
11. If a water is found, DO NOT OPERATE THE MACHINE. Shut off and repair.
12. Inspect machine for damaged or worn components and repair or replace to avoid
potential hazards. Do not operate the machine if any mechanical failure is noted
or suspected.
Waste Water Machines
1.
If any volatile chemicals such as gasoline or paint thinners are likely to
be contained in the waste to be processed, refer to the factory for further
instructions on enclosing and venting the equipment. Failure to do so may result
in fire and/or explosion. If gasoline or paint thinners are in the waste stream of
the waste water machine STOP operation immediately. Failure to do so may
result in a fire and/or explosion.
2.
Waste from this equipment may be hazardous. Check with your local authorities
for the correct disposal of accumulated wastes. Handle wastes with caution.
3.
Prior to working on any part of the equipment, stop the equipment, shut off the
water, and disconnect the electrical power. Prior to disassembling the filters,
drain the filters and release any pressure. Always first release any pressure.
Failure to do so may result in personal injury or damage to the equipment.
Carefully follow all instructions in operator's manual for adjustment of the filter
and/or securing devices.
4.
Never operate the pump dry. To do so, even for a short period, will result in
permanent damage resulting in leaks from the pump.
5.
Never operate the system with higher pressures than 10 PSI at any point in the
system.
Installation, Operation, Maintanance, Troubleshooting
Electrical Installation
7
Advertisement
Table of Contents
