Table of Contents
Advertisement
J
Always ensure that all the clamps and stops are
firmly held in place.
J
Never saw through more than one workpiece at
a time.
J
Ensure that the saw blade has reached full
speed before starting your cut and avoid using
too much force. In that way you will prevent the
saw blade from being blocked.
Operation
L
Assembly
L
Do not connect the chop and mitre saw to the mains
before you have worked through the following assembly
instructions and completely assembled the device.
1. Slide the lateral support stirrups
openings provided for them on the left and right
of the saw table
T
then fully tighten the clamp screws
2. Screw the saw table setting knob
threaded hole provided.
3. Loosen the saw table setting knob
Press the mitre angle stop
table
using the saw table setting knob
T
the basic position (0° setting).
4. When the mitre angle stop
the basic position (0° setting), turn the saw table
setting knob
to tighten it again.
O
5. Lightly press the switch handle
and pull out the transport lock
unit
tips upwards.
Q
6. Ensure that the machine is standing in a stable
position and check that the floor around the
machine is flat, clean and free of loose particles
such as sawdust chippings and sawing waste.
Using the four mounting holes
the chop and mitre saw on to a firm, level surface.
7. If you have not fastened the machine tightly
down to a working surface, pull out the rear
support stirrup
as far as possible to provide
e
maximum support to the machine.
into the
Y
until they meet the stop and
.
U
into the
O
again.
O
and turn the saw
I
O
has engaged in
I
downwards
W
. The saw motor
o
provided, fasten
}
Checking and setting your saw
L
Warning! Always disconnect the mains supply
(by pulling the plug out of the mains socket) before
you change any settings or check the condition of
the machine.
1. Parallel saw blade
j
Check that the saw blade is correctly installed; it
must be parallel to the sawing slot in the table. To
make any necessary settings proceed as follows;
j
Bring the saw table
(0° setting). Release the transport restraint by
lightly pressing the saw motor unit
wards and pulling out the transport lock
lock the machine by pushing the safety lever
to the right. Lower the saw motor unit
check that the side face of the saw blade is parallel
with the left hand edge of the sawing slot in the
table. The blade and the edge must be absolutely
parallel to one another. If necessary you can
change the setting by loosening the three
mounting screws
blade (see Fig. A) using the supplied 6 mm Allen
key (d) and bring the saw motor unit
parallel alignment. Then retighten the mounting
screws.
into
2. Stop plate
j
It is particularly necessary to check the stop
plate
if it has been removed from the machine
q
and put back again. The stop plate must be
perpendicular (at 90°) to the saw blade. This
setting can only be made after the saw blade
has been set as described above. To check the
stop plate
q
square. Set one end of the set square against
the stop plate and the other end against the side
face of the saw blade. If necessary you can
change the setting as follows:
j
Loosen the two screws on the rear face of the
stop plate
q
(d) and bring the stop plate
cular (90°) alignment to the side face of the saw
blade. Tighten the screws again.
Safety / Operation
into the basic position
T
Q
directly behind the saw
A
, we recommend that you use a set
using the supplied 6 mm Allen key
into a perpendi-
q
down-
. Un-
o
E
and
Q
into
Q
GB/IE
9
Advertisement
Table of Contents
