Summary of Contents for J5create JVAW51
- Page 1 Wireless HDMI Presentation System HDMI over Wireless Video JVAW51 User Manual JVAW51 User manual...
-
Page 2: Table Of Contents
Chapter 1: Product Introduction..................3 1-1 Package Contents....................3 1-2 Hardware Recommendation................3 1-3 Hardware Setup/Installation..................4 Chapter 2: Use JVAW51 to screen mirroring..............5 2-1 Pairing JVAW51 Tx and Rx..................5 2-2 Pairing OK, Ready to use..................6 Chapter 3: Box Configuration..................7 Chapter 4: Troubleshoot and FAQ..................9... -
Page 3: Chapter 1: Product Introduction
Chapter 1: Product Introduction Thank you for purchasing JVAW51. This section is going to introduce JVAW51 more details as below. 1-1 Package Contents 1. JVAW51 Transmitter (Tx) x 2 + Receiver (Rx) x 1 2. HDMI Cable 60cm x 1, 20 cm x 2 3. -
Page 4: Hardware Setup/Installation
1-3 Hardware Setup/Installation 1. Connect your device 2. Wait a few seconds for the screen below to load. After few seconds, the Rx Box is in standby mode and ready to do screen mirroring from your device. -
Page 5: Chapter 2: Use Jvaw51 To Screen Mirroring
Chapter 2: Use JVAW51 to screen mirroring. 2-1 Ready to use. Factory paired completed, Tx is ready to screen mirroring. ... -
Page 6: Chapter 3: Box Configuration
Chapter 3: Box Configuration •LED •Button and Switch for Tx... - Page 7 •Button and Switch for Rx...
-
Page 8: Chapter 4: Troubleshoot And Faq
Chapter 4: Troubleshoot and FAQ • Tx didn't receive HDMI in data. Please check the HDMI in is unplugged or not. • Disconnected Please check the Tx HDMI connecton and power cable connecton. - Page 9 •What's video mode and presentaton mode? Mode indication is shown before mirroring. Presentation mode is designed with lower latency. Video mode is designed with higher FPS and the video play is smooth.
- Page 10 What's supported resolution of Tx HDMI in? How to upgrade FW? For Tx Step1. Copy the FW into SD Card and insert the SD Card into SD Card slot. Step2. Press the Fn button to power up and don't connect the HDMI in. LED is red. Step3.
- Page 11 Step2. The LED will start to flash green. Please allow up to 5-10 seconds for the process to finish. Step3. The power LED will turn solid green when the JVAW51 RX /TX has connected successfully Step4. The JVAW51 TX is now ready to share the extended...
- Page 12 REGULATORY COMPLIANCE FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.