Table of Contents
Advertisement
6.0 Configurations and Connections
6.1 Network Configuration & Adding IP Camera
1.
2. Enter HTTP port (the default value is 80) and server port (the default port is 6036).
3. The internal ethernet port is the port which connects all the PoE ports with the NVR
4. Add Camera. Click "Next" to go to the following interface.
5. Click
10
Enter IP address, subnet mask, gateway, etc. If using DHCP, please enable DHCP in both
the NVR and the router.
system. The PoE ports are available if the internal ethernet port is online, if it is offline,
all the PoE ports will be unavailable.
to edit an IP camera as shown on the above left. Enter the new IP address,
subnet mask, gateway, username and password of the camera. Click "OK" to save the
settings. Click
to edit the added camera as shown on the above right. Enter the
new camera name, IP address, port, username and the password of the camera. You
can click "Test" to test the effectiveness of the input information. Click "OK" to save the
settings. You can change the IP camera name only when the added camera is online.
Click "Next" to continue.
Click "Refresh" to refresh the list of online
IP cameras which are in the same local
network with the NVR. Click + to add the
searched camera. Click "Add All" to add all
the cameras in the list. Click
added camera. Click "Delete All" to delete all
the added cameras.
to delete the
Advertisement
Table of Contents
