Connecting The Loudspeakers - Klipsch Palladium P-17B Owner's Manual

Page 10

Connecting the Loudspeakers - 2

The Terminal Panel
As supplied, positive and negative terminals of the high and low frequency terminal pairs are strapped to-
gether with a two-way strap. This is how you should prepare the terminal panel for each wiring option.
Standard Connection
No preparation
needed
Standard (Single) Wiring
The straps are left in place as supplied. Connection may be made to any pair of terminals.
You will need two loudspeaker cables of equal lengths, one for each loudspeaker.
Partially unscrew one positive and one negative terminal. Connect the positive (+ RED) terminal of the loud-
speaker to the striped conductor, or (if you are using custom cable) to the conductor designated by the cable
manufacturer. Connect the negative (– BLACK) terminal to the plain conductor. Do not connect the amplifier
at this time.
HF HF
Right Speaker
Bi-wiring Connection
Loosen the terminals.
Remove the straps
Re-tighten all
terminals hand tight
AMPLIFIER
Left Speaker