Advertisement
5. Adjustment
C
D
Tension is pre-set at the factory. If too tight or too loose, you may adjust the tension by loosening or tightening
the adjustment bolts.
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your dealer if you have any questions.
11
+15°
180°
-15 °
Full Motion LED, LCD TV Wall Mount
info@huskymount.com
75x75/100x100
FM-32 FBA
200x100/200x200
INSTALLATION INSTRUCTIONS
CAUTION:
DO NOT EXCEED MAXIMUM
LISTED WEIGHT CAPACITY. SERIOUS
INJURY OR PROPERTY DAMAGE MAY
OCCUR!
42"
30kg
30kg
MAX
(66lbs)
(66lbs)
MAX
MAX
Advertisement
Table of Contents
Related Manuals for Husky Mounts FM-32
Summary of Contents for Husky Mounts FM-32
- Page 1 • Check that the bracket is secure and safe to use at regular intervals(at least every three months). • Please contact your dealer if you have any questions. CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! 42" 75x75/100x100 FM-32 FBA 30kg 30kg 200x100/200x200 (66lbs) (66lbs)
- Page 2 Component Checklist NOTE: Read the entire instruction manual before you start installation and assembly. IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, please contact the seller for replacement. WARNING •...
- Page 3 1b. Mount on Solid Brick and Concrete Block 1a. Mount on Wood Stud Wall (do not use Concrete anchors W-B) (the use of the concrete anchors W-B is necessary) 55mm 55mm (2.2") (2.2") 60mm 60mm (2.4") (2.4") ø 4.5mm (ø 3/16") ø...
- Page 4 2. Install Cable Clip 3. Hang the TV onto the Wall Mount Install two screws into the upper mounting holes on the TV and tighten screws spacing 2mm to TV / spacers. Note: if spacers are used, they should be placed between the mounting plate and the back of TV, and not between the mounting plate and the head of the screw.
- Page 5 For VESA200x100 200x200 Lower the TV firmly into place. Lift your TV and fit screws into the mounting holes on the mount. Install two remaining screws through the lower mounting holes on the mount into the TV. Note: Keep your hand on the TV until all the screws are installed. Tighten all screws at this time but do not over tighten.
- Page 6 For VESA 75 75 1 00x 00 Lift your TV and make screws on the TV fit into the mounting holes on the mount. Install two remaining screws through the lower mounting holes on the mount into the TV. Note: Keep your hand on the TV until all the screws are installed. Tighten all screws at this time but do not over tighten.
Need help?
Do you have a question about the FM-32 and is the answer not in the manual?
Questions and answers