Apollo T8LED9WWG-G13 TEOS User Manual page 6

Diagram of the luminaire -
before the modifications of the
electrical circuit
Luminaire wiring diagram
adapted to power one LED
tube - after the modifications
of the electrical circuit
Luminaire wiring diagram
adapted to power two LED
tubes - after the modifications
of the electrical circuit
Luminaire wiring diagram
adapted to power four LED
tubes - after the modifications
of the electrical circuit
Warning:
Installation of this product should be done by a
licensed electrician.
LED tubes can't be mounted in series:
6. LED tube should be put into holders of luminaire and then rotated by 90 degrees to make an electrical
connection.
Attention:
Pins of tube which should be connected to voltage (230V 50Hz) are marked with letters L N and
'INPUT' word
7. Check if connections inside luminaires are proper
8. Turn on power supply 230V 50Hz
:
During installation
remove or disconnect
ballast and starter.
Electrical circuit
should be done
according to scheme:
During installation
remove or disconnect
ballast and starter.
Electrical circuit should
be done according to
scheme:
During installation remove or
disconnect ballast and starter.
Electrical circuit should be done
according to scheme:
Warning:
Luminaire after modifications
of electric citcuit can't be
used with fluorescent tubes.