Lucid Technologies RB01 User Manual

Rocket beeper

ROCKET BEEPER

RB01

USER'S MANUAL

2022.01.02

Lucid Technologies

http://www.lucidtechnologies.info/

Email: info@lucidtechnologies.info

The information in this manual has been carefully checked and is believed to be accurate.

However, Lucid Technologies makes no warranty for the use of its products and assumes no

responsibility for any errors which may appear in this document. Lucid Technologies reserves the

right to make changes in the products contained in this manual in order to improve design or

performance and to supply the best possible product. Lucid Technologies assumes no liability

arising out of the application or use of any product or circuit described herein; neither does it

convey any license under its patent rights, nor the rights of others.

Table of Contents

Need help?

Do you have a question about the RB01 and is the answer not in the manual?

Page 1 The information in this manual has been carefully checked and is believed to be accurate. However, Lucid Technologies makes no warranty for the use of its products and assumes no responsibility for any errors which may appear in this document. Lucid Technologies reserves the right to make changes in the products contained in this manual in order to improve design or performance and to supply the best possible product.
Page 2 RB01, Rocket Beeper Contents Specifications Description Battery requirements Using the RB01 Attaching the RB01 Securing the battery Turn on the RB01 Specifications Mass " Approximately 8.8 grams without battery Dimensions " Diameter 24.5 mm " Length 51.6 mm " Compatible with BT-55 or larger body tubes Power "...
Page 3 - the RB01 uses a phototransistor to turn off the beeper when it is dark. This means that after you turn the RB01 on and put it inside your rocket - where it is dark - it will cease beeping until it sees daylight again after ejection.
Page 4 See the pictures on the next page. Turn on the RB01. When you are ready to launch your rocket, move the jumper on J2 from the OFF position to the ON position. The beeper will start to sound until you put the RB01 back in the rocket and secure the nose cone.
Page 5 RB01, Rocket Beeper Figure 5. RB01 bottom view Figure 4. RB01 top view...