Ultrasonic essential oil diffuser and air humidifier (19 pages)
Summary of Contents for VOCOlinc VS1
Page 1
VS1. You can also use the VS1 to trigger scenes for home automations (e.g. open window > turn on humidifier). The VS1 uses Bluetooth low energy technology (BLE) and a replaceable battery (CR2032), which gives you up to 6 months of battery life.
Page 2
2 Reset Button Press & hold for about 5 seconds: factory reset All connection data will be cleared. You must remove the accessory from the app and add it back. 3 Contact Sensor Built-in 4 Magnetic Piece LED Indicators Status Status Status indication LED status Pairing Process...
3M Adhesive ×2 Key Features: Bluetooth low energy technology 5.0 Real-time status notifications Automate your home by triggering scenes Status LED Up to 6-month battery life (replaceable battery) Compact design Specification Battery: CR2032, DC 3V 220mAh Operation Temperature:0-40℃ Purpose of control:Electrical control Type of action: Type 1.C Control Pollution Degree: PD 2 Number of operation cycles: 10,000...
Page 4
Quick Start Guide Installation 1. Open the battery cover located on the back of the contact sensor with the aid of tools and insert the button battery (CR2032) into the contact sensor. Starting the pairing process (please refer to “pairing”). Open the battery cover Insert the button battery...
Page 5
3.During installation, make sure to align the dot marker on each of the two pieces,also ensuring the gap between the two halves is less than 20mm when the door/window is closed. Use spacers to level the two pieces up (shown in diagram).
Page 6
Connect your iOS device to the internet and make sure Bluetooth is On, then follow the steps below: 1. Download and open the free VOCOlinc LinkWise app from the Apple App Store. 2. Enter “pairing mode” by pressing and holding the button for 5 seconds, until a green LED appears and flashes for 3seconds.
Page 7
● The device must be disconnected from the supply mains(where appropriate) when removing the battery; The battery is to be disposed of safety; ● ● Using incorrect type batteries can cause damage to people or the accessory. Caution: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 8
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. In order to avoid the possibility of exceeding the ISEDC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
Need help?
Do you have a question about the VS1 and is the answer not in the manual?
Questions and answers