RO Bucket Single Post RO Manual

Advertisement

High Capacity Single Post RO
Revision 1
Responsible Use and Liability Disclaimer
The products offered by The RO Bucket LLC are intended for use by
individuals who have become knowledgeable regarding the reverse
osmosis process as it relates to maple syrup production. Follow all
indications and directions and observe reasonable care when
utilizing this product. Possible hazards associated with the use of the
product include, but are not limited to:
Shock/Electrocution - Always use a ground fault outlet and
surge protector. Always wear shoes and keep electrical
cord away from wet/moist surfaces. Always run discharge
hoses into containers. Never allow them to spill onto
nearby surfaces.
Fire - Do not use the product in potentially explosive,
flammable, or corrosive environments. In the event the
thermal protection function is enabled, unplug the unit and
wait one hour before using again. Do not disassemble or
alter the motor or driver. Use only the provided
transformer.
Physical hazards - The product works under high
pressure. Always wear safety goggles and point hoses away
from your body and face.
Leaks – Closely monitor the operation of the product.
Regularly inspect and repair any components that are
leaking.
In no event shall The RO Bucket LLC be liable for any direct, indirect,
punitive, incidental, special, or consequential damages to property or
life whatsoever arising out of or connected with the use or misuse of
our products.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Single Post RO and is the answer not in the manual?

Questions and answers

Summary of Contents for RO Bucket Single Post RO

  • Page 1 Regularly inspect and repair any components that are leaking. In no event shall The RO Bucket LLC be liable for any direct, indirect, punitive, incidental, special, or consequential damages to property or life whatsoever arising out of or connected with the use or misuse of our products.
  • Page 2: Specifications

    Prefilter replacement 10 brix in a single pass. c. Membrane replacement Specifications: 6. Sap concentration The high capacity single post RO system features: 7. Membrane cleaning  3/4hp 110v electric motor (can be wired for 240v), draws 10.4A 8. Storage ...
  • Page 3 Diagram: 4. Working Theory of System: The high capacity single post RO system utilizes a 200gph high-pressure pump. These vane style pumps can not be allowed to run dry. A 100 mesh intake strainer can be found on the inlet side of the pump and is used to keep large particles from entering the pump head.
  • Page 4: Initial Start Up And Maintenance

    After 5 minutes, ensure that concentrate and permeate are Initial Start Up and Maintenance flowing out of the discharge hoses. Minor assembly is required on our shipped dolly systems. 8. This completes the initial start up rinse and inspection. You Assemble using the supplied literature.
  • Page 5: Membrane Cleaning

    1. Drain the membrane housing by opening the lower concentrate drain valve. 2. Place the concentrate and permeate hoses into the raw sap 2. Loosen the two 14mm bolts on the upper housing cap and container (allow to recirculate until the system fills). 3.
  • Page 6: Warranty

    4. valve fully open and the recirculation valve fully closed. Allow the discharge hoses to run to drain. 3. Run the system for 30 minutes (recirculation with all three 5. Turn off the pump before it runs dry. Leave the system full of hoses in the same bucket).

Table of Contents