Advertisement
CLEANING THE UNIT
• Unplug the wrapping station before cleaning and/or servicing.
• When Cut Off Bar and/or hot plate becomes dirty, clean with a cotton cloth. Do not use metal
or other abrasives. Do not immerse the wrapping station in water or other liquids.
• Do not spray cleaners or liquids onto any electrical components.
Noble Chemical's Strike all purpose cleaner and degreaser makes it easy to keep your kitchen clean.
Attack tough grease, oil, and carbon with this ready-to-use cleaner and degreaser. Its unique formula
is designed to clean concrete, machinery, engines, floors, walls and more!
servicing THE UNIT
• This wrapping station should only be serviced by trained personnel.
• Unplug the wrapping station before servicing.
• Do not attempt to repair or replace any parts other than the replacement parts listed in these
instructions. Improper repair or replacement may result in electrical hazards and will void the
warranty.
fuse replacement
1. Unplug the wrapping station before servicing.
2. Situate the wrapping station on a stable surface so that the back of wrapping station
is accessible.
3. Turn the fuse holder cap counterclockwise to loosen until it is released from the fuse
holder receptacle. The fuse will be attached to the cap.
4. Remove the fuse from the fuse holder cap by pulling gently.
5. Replace fuse with only type 1A (part PWM18212).
6. Insert new fuse into fuse holder cap.
7. Insert fuse holder cap with fuse into the fuse cap receptacle.
8. Turn the fuse holder cap clockwise to tighten until it is hand tight.
9. Situate the wrapping station into normal operating position on a stable surface.
10. Plug the wrapping station into a properly grounded outlet.
4
Advertisement
