Table of Contents
Advertisement
3
Hardware Setup
3.5.2 OM-DAQ-USB-2401 DIN Rail Mounting
In order to mount the OM-DAQ-USB-2401 to a DIN-Rail, you will need to:
1. Attach the DIN-rail plastic adaptors to the mounting brackets, using the four
shorter screws.
2. Remove the rear screws from the OM-DAQ-USB-2401.
3. Align the mounting brackets with the rear holes on the DAQ unit (make sure
that the ears are facing inwards, like in the figure below).
4. Use the longer screws to reconnect the mounting brackets to the body of the
enclosure, in the same direction as the screws that were removed from the
DAQ unit.
5. Attach the DAQ unit to the DIN rail, using the plastic adaptors attached to the
mounting brackets.
3-8
Figure 3-7. OM-DAQ-USB-2401 Rail Mounting
Advertisement
Table of Contents
