Advertisement
INSTALL OPERATING PANEL
1. Starting at one end,
press the panel track
with the higher side
toward the interior,
into the sill until it
snaps into place.
NOTE:
Install panel
with latch hook
pointing upward and
facing the keeper in
the side jamb, and
the interlock facing the fixed panel.
ALIGN LOCK KEEPER
1. Mark jamb at top of
keeper with a pencil.
2. Unscrew and
remove keeper.
3. Mark another line
3/8" below previously
marked line.
4. Mark the center of the
slotted holes and drill
3/32" pilot holes.
5. Install keeper with top
at lower pencil mark.
3 3
Installation Instructions
for Builders Vinyl Sliding Patio Door Handing Reversal (SVC001)
Interior
side
3/8"
Keeper
Jamb
2. Place operating panel next to the door in an open position. Lift the
panel, place the top into the operating panel track in the head and
swing the bottom over the sill and rest the rollers on the track.
3. Adjust rollers until the panel just clears the track.
4. Install security anti-lifts with flat section facing the exterior into the
operating panel track in header so they will be above the operating
panel when it is closed.
6. Test operation by closing and locking operating panel. If door does
not lock tightly, loosen screws, adjust keeper up or down, then
retighten.
7. When the lock operates correctly, mark and drill 3/32" pilot holes in
the remaining two holes and secure with screws.
8. Wipe off marks (pencil will easily wipe off vinyl).
Advertisement
