Advertisement
Assembly
1. Remove the cover ⑤ from the base plate ④.
2. Hold the base plate ④ against the wall at the desired loca-
tion and mark the four drill holes horizontally.
Important: The base plate must be rotated by 90° for
mounting a center speaker in landscape format.
3. Drill holes with a diameter of 6 mm in the wall at the
marked positions.
4. Insert four masonry plugs ⑨ in the drill holes.
5. Run the speaker cable through the holes in the base plate
④ from below.
Speaker cable
⑤
6. Screw the base plate ④ on the wall using four half round
head wood screws ⑧.
7. The cover ⑤ is marked with "TOP" and "DOWN" inside.
Run the upper end of the speaker cable through the upper
hole in the cover ⑤.
8. Put the cover ⑤ on the base plate ④. Do not pinch the
speaker cable in the process!
9. Place the bracket ⑥ on the base plate ⑤ and insert the
screw ⑦ with a washer ⑬ from above.
10. Tighten the screw ⑦ with a washer ⑬ and a nut ⑩.
⑧
④
⑨
⑦
⑬
④
⑬
⑩
⑥
11. From the three retaining plates ① ② ③, choose the one
which fi ts the hanger of your speaker:
① for a hole spacing of 30, 31 or 32 cm
② for a hole spacing of 27 cm
③ for a hole spacing of 20.5 cm
12. Screw tighten the appropriate retaining plate to the
bracket ⑥ using four screws ⑪ and four nuts ⑭.
⑪ ⑫
13. Loosely screw the two retaining bolts ⑫ on the top and
bottom of the retaining plate ①, ② or ③ using one nut ⑭
each (only two to three turns).
Page 3
②
①
①
⑩
⑭ ⑥
②
③
③
Advertisement
