MyTana M888 Owner's Manual

Cable machine

Advertisement

- IMPORTANT -
THIS MACHINE IS NOT TO BE
OPERATED BY ANYONE UNTIL
HAVING CAREFULLY READ
THIS INSTRUCTION BOOK ON
ITS USE.
IF ANYONE ELSE THAN THE
ORIGINAL BUYER OF OUR
EQUIPMENT IS TO USE THE
MACHINE, THEN HE or SHE IS
TO BE FURNISHED WITH AN
INSTRUCTION BOOK.
Replacement manuals are
available online at mytana.com/
product-manuals
M88
base unit:
no cable, reel
or rev arm
022222
Manufacturers of Quality
Sewer & Drain Cleaning
Equipment since 1957
M888 Cable Machine
Owners Manual
Please inspect your machine carefully upon receipt.
Let us know immediately if you note any damage.
www.MyTana.com
746 Selby Ave • St. Paul, MN 55104
fax: (651) 222-1739
M88 shown with optional
cable, reel and rev arm.
(800) 328-8170
Factory Direct Customer Service
M –F 7am – 5pm CST
Competent • Polite • Clear

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M888 and is the answer not in the manual?

Questions and answers

Summary of Contents for MyTana M888

  • Page 1 M888 Cable Machine Owners Manual Please inspect your machine carefully upon receipt. Let us know immediately if you note any damage. - IMPORTANT - THIS MACHINE IS NOT TO BE OPERATED BY ANYONE UNTIL HAVING CAREFULLY READ THIS INSTRUCTION BOOK ON ITS USE.
  • Page 2: Identifying Parts

    PG 2 MyTana M888 UPRIGHT WORKHORSE User Manual Identifying Parts Control Panel Cord wrap Forward/reverse switch GFCI circuit Safety On-Off toggle switch— Main power must be in "On" receptacle position for foot pedal Gearbox to work Drive arm with cleat...
  • Page 3: Foot Pedal

    PG 3 MyTana M888 UPRIGHT WORKHORSE User Manual Assembly Mount reel onto machine Grasp the reel firmly and lift it Feed the cable through the up so that the back center of Autofeed. the hub aligns with the main Position the revolving arm drive shaft.
  • Page 4: Operation

    PG 4 MyTana M888 UPRIGHT WORKHORSE User Manual ALL OPERATORS: Read the operating instructions on the these pages before operating equipment. u BEFORE STARTING your u SHUT OFF THE MOTOR u SAFETY Operators should wear first job – Read the paragraph WHEN NOT IN USE –...
  • Page 5: Reverse Switch

    PG 5 MyTana M888 UPRIGHT WORKHORSE User Manual As you operate the machine, place one hand on the cable Figure 4 close to the switch or Autofeed (figure 4) to prevent any throwing of the cable. Gently pull the cable out of the machine a little at a time.
  • Page 6 Adding Reels If the line is longer than the amount of cable you have on the reel, MyTana makes it easy to swap in a new reel so you can work at a greater distance. When back end (anchor) cable fitting is about in this location, it is time to add another reel.
  • Page 7 Continuous foot opposite the dramatically. MyTana’s MT21 is a water based treatment pressure near or on hose fitting. that also deodorizes. You can also hose down the cable the hose fitting can...
  • Page 8 PG 8 MyTana M888 UPRIGHT WORKHORSE User Manual (800) 328-8170 MyTana.com mytana@mytana.com youtube.com/videoMyTana EMAIL M–F 7a to 5p CST ©2022 MYTANA LLC 746 SELBY AVE • ST. PAUL, MN 55104...

Table of Contents