Honda RedGum Silver Plus+ Lifter Owner's Manual page 10

IMPORTANT OPERATION INSTRUCTION
Correct Placement of logs onto the Log Splitter is Required Prior to Splitting Logs in
order to Prevent Damage to the End Plate, Splitting Wedge & Splitting Beam
Correct operating procedures are required to ensure your RedGum log splitter is not
damaged. Incorrect operation can result in bending the Beam (6), Splitting Edge (4) and/or
End Plate (22). Important: If Beam, Wedge or End Plate are bent due to incorrect operation,
it is not the manufacturers fault and subsequently would not be covered under warranty.
Ideally the log should be cut into "rounds" with flat or even surfaces. If they are cut and the
edges are on an angle or have an uneven surface, you must ensure you place the log onto
the Beam (6) as shown in the Second or Third diagrams, as shown below:
10.