Built-In Cd Player; Playing A Cd; Introduction Of Advanced Built-In Cd Player Operation; Repeating Play - Pioneer DEH-P5800MP Operation Manual

Built-in CD Player

Playing a CD

These are the basic steps necessary to play a CD with your built-in CD player. More
advanced CD operation is explained starting on this page.
Play time indicator
Shows the elapsed playing time of
the current track.
Track number indicator
Shows the track currently playing.
1. Press OPEN to open the front panel.
CD loading slot appears.
• After a CD has been inserted, press SOURCE to select the built-in CD player.
2. Insert a CD into the CD loading slot.
Playback will automatically start.
• You can eject a CD by pressing EJECT.
• To avoid a malfunction, make sure that no
metal object comes into contact with the
terminals when the front panel is open.
3. Close the front panel.
4. Use VOLUME to adjust the sound level.
Rotate it to increase or decrease the volume.
5. To perform fast forward or reverse, press and hold 4 or 6.
• If you select ROUGH, pressing and holding 4 or 6 enables you to search every 10
tracks in the current disc. (Refer to "Selecting the search method" on page 16.)
6. To skip back or forward to another track, press 4 or 6.
Pressing 6 skips to the start of the next track. Pressing 4 once skips to the start of the
current track. Pressing again will skip to the previous track.
Notes
• The built-in CD player plays one standard, 12-cm or 8-cm CD at a time. Do not use an
adapter when playing 8-cm CDs.
• Do not insert anything other than a CD into the CD loading slot.
• If you cannot insert a disc completely or if after you insert a disc the disc does not play, check
that the label side of the disc is up. Press EJECT to eject the disc, and check the disc for
damage before inserting it again.
• If an error message such as ERROR-11 is displayed, refer to "Understanding built-in CD
player error messages" on page 32.
• When a CD TEXT disc is inserted, the disc and track titles begin to scroll to the left
automatically.
CD loading slot
EJECT button

Introduction of advanced built-in CD player operation

Function display
Shows the function status.
RPT indicator
Shows when repeat play is turned
on.
* Press FUNCTION to display the
function names.
Press FUNCTION repeatedly to switch between the following functions:
RPT (repeat play) – RDM (random play) – SCAN (scan play) – PAUSE (pause) –
COMP (compression and BMX) – FF/REV (search method)
• To return to the playback display, press BAND.
Note
• If you do not operate the function within about 30 seconds, the display is automatically
returned to the playback display.

Repeating play

Repeat play lets you hear the same track or disc over again.
1. Press FUNCTION to select RPT.
Press FUNCTION until RPT appears in the display.
2. Press 4 or 6 to select the repeat range.
This switches you to the selected setting.
• RPT:DSC – Repeat the current disc
• RPT:TRK – Repeat just the current track
Note
• If you perform track search or fast forward/reverse during TRK, the repeat play range
changes to DSC.
15