The First Wash Cycle - Indesit PWDE 8148 S Instructions For Use Manual

As the colours of the wires in the lead may not
GB
correspond with the coloured markings identifyng the
terminals in your plug, proceed as follows:
Connect Green & Yellow wire to terminal marked E or
or coloured Green or Green & Yellow.
Connect Brown wire to terminal marked L or coloured
Red.
Connect Blue wire to terminal marked N or coloured
Black.
If a 13 amp plug (BS 1363) is used it must be fitted with a
13 amp fuse, either in the plug or adaptor or at the
distribution board.
If you are in any doubt about the electrical supply to your
machine, consult a qualified electrician before use.
How to connect an alternative plug:
The wires in this mains lead are coloured in accordance
with the following code:
BLUE
BROWN
GREEN & YELLOW
Disposing of the appliance:
When disposing of the appliance please remove the plug
by cutting the mains cable as close as possible to the
plug body and dispose of it as described above.
GREEN &
YELLOW
BROWN
BLUE
!
The washing machine should not be installed in
an outdoor environment, not even when the area is
sheltered, because it may be very dangerous to leave it
exposed to rain and thunderstorms.
!
When the washing machine is installed, the mains
socket must be within easy reach.
!
Do not use extensions or multiple sockets.
!
The power supply cable must never be bent or
dangerously compressed.
!
The power supply cable must only be replaced by an
authorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.
4
NEUTRAL (N)
LIVE (L)
EARTH (E)
13 ampere fuse
CROSS-BAR
CORD GRIP

The first wash cycle

Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, setting the 90°C programme without a pre-wash
cycle.