Table of Contents
Advertisement
GETTING STARTED
Charging Your i1166
Before using this unit with the built-in Li-Polymer rechargeable battery, please FULLY CHARGE
THE BATTERY first. If this is not done, discharging time will be short. The battery operates normally
at maximum capacity after 4~5 times of charging and discharging. After a period of storage or
non-usage for an extended period of time, please fully charge the battery again before using it. The
battery is fully charged after approximately 3-4 hours after the AC adapter is connected.
1. Connect to the AC adapter according to the instructions in the section "Using the AC Adapter. "
2. Once the AC adapter is connected, the battery recharge will start. While the battery is charging,
the LED indicator on the right side will light RED. When charging is complete, the LED indicator
will light GREEN.
3. Disconnect the AC adapter plugs from both the player and the AC outlet when charging is
complete or not necessary.
Note: The built-in battery can be charged in both the power-on and power-off modes, in power-on mode, the
charge time will be longer than power-off mode.
Low Battery Indication
When using the rechargeable battery to play, the charge will eventually weaken. When the battery
is almost empty, the LED indicator will begin to flash in red, and "low battery" icon will display on
LCD. To recharge the battery, refer to the instructions in the section "Charging Your i1166. "
Charging Your iPod
1. Insert your iPod into the dock carefully and close the dock cover.
2. Connect the supplied AC adapter to the unit. It will automatically charge your iPod.
3. Disconnect the AC adapter when not necessary.
Note: iPod will not be charged in power off state if AC adaptor is not connected.
Connecting Headphones (not included)
Use 3.5 mm stereo headphones with this product.
Warning: Hearing experts have found that using headphones at high volume over an extended time may cause
damage to or loss of hearing.
9 | iLuv
OPERATIONAL INSTRUCTIONS
General Playback Instructions for iPod
To play your favorite iPod music and watch videos on the LCD screen, follow the instructions below:
1. Before setting, insert your iPod into the dock carefully and close the dock cover.
2. Connect the AC adapter to the main unit and slide the POWER OFF/ON switch on the main unit
to the ON position.
3. The LCD will show the mode selection
screen after few seconds.
4. Press < or > to highlight the iPod mode, press
SELECT to confirm, the unit will start to authenticate
the iPod and the LCD will show "iPod Authenticating,
Do not disconnect".
Note: If this message continues to display on the LCD for more than
twenty (20) seconds, remove your iPod and re-insert into the dock
for verification again.
Sometimes, if your iPod is frozen, it needs to be reset. To do this,
press the Menu and Center buttons on your iPod for six to ten (6-10)
seconds until the Apple logo appears on the screen. When your
iPod returns to normal operation, connect it to the i1166. Please
see the instruction manual for your iPod for detailed information
on resetting.
5. After 3-5 seconds, verification will complete and
LCD will show the iPod home menu (Music, Video,
Setting). You can now operate your iPod using the
remote control or the function keys on the unit.
i1166 | V10M10_IM_EN_091509
iLuv | 10
Advertisement
Table of Contents
