Advertisement
Congratulations on your purchase of a state of the
art wireless Sun Winch™ Grow Light Lift System!
To ensure that you get the most out of your Sun Winch™ lift kit, please
read these instructions completely and carefully BEFORE installing or
operating your system.
The Sun Winch™ lift system is designed to control a total lighting load of
not more than 50 pounds. Ensure that the light, ballast (if required) and any
hood vent hardware DOES NOT EXCEED 50 pounds.
SunWinch™ Kit Components
• 2 SunWinch Lift Motors
•
•
•
•
To operate your Sun Winch™ Grow Light Lift System you will need to
purchase a Sun Winch™ Remote. Each remote is designed to control
8 Sun Winch™ lift kits. The SunWinch™ Remote is sold separately.
Sun Winch
Grow Light Lift Kit
Product #710180
1 Receiver
1 Power Supply
2 Lift Motor Cords
3 Mounting Rail Sections
Scan here for
instructional video
TM
1
Advertisement
Table of Contents
Summary of Contents for Sunlight Supply Sun System Sun Winch 710180
- Page 1 Sun Winch Grow Light Lift Kit Product #710180 Congratulations on your purchase of a state of the art wireless Sun Winch™ Grow Light Lift System! To ensure that you get the most out of your Sun Winch™ lift kit, please read these instructions completely and carefully BEFORE installing or operating your system.
- Page 2 INST ALLATION 1.nInstall the 3 mounting rail sections into an existing overhead support using the screws provided. It is the user responsibility to ensure that the support used is adequate to bear the weight of the lift system and grow light with associated hardware. The center holes on the 2 outside mounts should be spaced to accommodate the length of the grow light mounts.
- Page 3 OPERATION To lift your grow light to the desired height, press the station button once and then a direction button. HOLD DOWN the direction button until the desired height is reached. Release the direction button. PROGRAM ST ATION NUMBER Your Sun Winch™ Lift receiver is pre-programmed to STATION 1. To change the station number of a receiver, read the following instructions. Remove the cover on the receiver by removing the four small screws.
- Page 4 Specializing in the wholesale of indoor horticulture, organics & hydrogardening supplies. Vancouver, WA • Livermore, CA • Ontario, CA • Samoa, CA Denver, CO • Wixom, MI • York, PA • Nashville, TN • Pompano Beach, FL www.sunlightsupply.com ©2014, Sunlight Supply, Inc.
Need help?
Do you have a question about the Sun System Sun Winch 710180 and is the answer not in the manual?
Questions and answers