Gainsborough K232 Quick Manual

1.5m Solar Willow Tree
K232
v001: 11/10/21
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
BEFORE FIRST USE: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set switch (located on the back of solar case) to "S (steady on)" OR "F (flash)" position. Charge the
solar product by placing it under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the day
time and illuminate at night.
NOTE: In order to verify that the switch is correctly in the "S" OR "F" position, cover the solar panel with
your hand and the light should turn on automatically.
Find an ideal Place for the Solar Light.
Place the solar panel in an area where it will receive direct sunlight for at least 8 hours per day. The number
of hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the panel is
placed in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not
place the solar panel near other outdoor lighting like porch or streetlights. These may fool the sensor and
keep the light from coming on, or cause it to turn off automatically
Dimensions
(H) 150 x (W) 22 x (D) 22cm
Material
Silk and Plastic
Battery
1x AA 1.2v 600Mah, Ni-MH, Rechargeable (included)
•
PRETTY WEEPING WILLOW TREE IS SCATTERED WITH WARM
WHITE SOLAR LIGHTS
•
THE CASCADING LEAVES WILL RUSTLE IN THE WIND
•
POSITION BY A DOOR, IN A CORNER OF YOUR PATIO,
FLOWER BED ETC AND ENJOY DAY AND NIGHT
•
SEPARATE SOLAR PANEL SO YOU CAN POSITION IN OPTIMAL
SUN LIGHT
•
120 WARM WHITE LEDS (NOT REPLACEABLE)
•
12 BRANCHES EACH AROUND 90CM LONG AND WITH 10
LEDS ON
•
COMES WITH 4 GROUND PEGS TO FIX THE BASE INTO SOFT
GROUND
ALWAYS POSITION IN DIRECT SUNLIGHT