Place the water dispenser on a level surface. Make sure that there is at least 4 inches of space between the back of you water dispenser and the wall. Keep a minimum distance of 2 inches on each side of you water dispenser free;...
- The hot water thermostat is factory set between 88°C adn 89°C (190.4°F and 192.1°F). - Before the water dispenser leaves the factory, the thermostat is set properly. It is not advisable to adjust the thermostat when using the water dispenser.
WATER DISPENSER MAINTENANCE 1- Always turn your water dispenser off when there is no water left in the bottle or when you are changing bottles. Turn it back on after the new bottle has been placed and the air purged from the dispensing buttons.
1a- The power cord is plugged in porperly b- If the water dispenser is bought in from outside in the winter time, give it a few hours to warm up to room temperature before plugging it in. The thermostat setting may be affected by the coldness of the water dispenser itself or the bottled water.
FONTAINE D’EAU MANUEL D’UTILISATION MODELE: MWC529...
Page 7
ELECTRICITE ET SECURITE L’utilisation d’appareils électriques nécessite le respect de certaines précautions élémentaires, afi n de reduire le risque d’incendie, de choc électrique, de blessures ou de dommages à la propriété. Lire toutes les instructions avant l’utilisation de n’importe quel appareil - Eviter de toucher l’eau chaude qui sort de l’appareil.
Page 8
CARACTERISTIQUES DE VOTRE DISTRIBUTEUR D’EAU Pour l’eau froide, on retrouve un réservoir de refroidissement en acier inoxydable. Pour l’eau chaude il y a un réservoir en acier inoxydable résistant avec un réchauffeur externe. Il convient à l’eau minérale. Thermostat sur le panneau arrière. 2 interrupteurs à...
ENTRETIEN DU DISTRIBUTEUR D’EAU 1-Eviter d’allumer et d’éteindre rapidement les interrupteurs d’alimentation. La surtension qui en résulté peut endommager les distributeur. 2- Toujours éteindre le distributeur lorsq’il ne reste plus d’eau dans la bouteill et au moment de changer la bouteille d’eau. Allumer l’interrupteur de nouveau après avoir mis une nouvelle bouteille et avoir retiré...
Page 10
DIRECTIVES EN CAS DE PROBLEMES Problème : 1- L’interrupteur du système de refroidissement est allumé, mais le compresseur ne fonctionne pas. Vérifi er : 1a- Le cordon d’alimentation est bien branché 1b- Si le distributeur arrive de l’extérieur en hiver, attendre quelques heures avant de la brancher afi n qu’il se réchauffe à...
Need help?
Do you have a question about the MWC529 and is the answer not in the manual?
Questions and answers