Summary of Contents for LockMasters LKMRT1KIT
- Page 1 Large RiteThru Tool Instructions Lockmasters Part Number - LKMRT1KIT Supplied in a Pelican-like Case...
- Page 2 INTRODUCTION • Proper planning. • Placing the tool on the door for surface preps • Transfer the holes • Core drilling from hinge side to lock side • Aligning the tool to hit the target • Recommendations for drilling • Storage and cleaning PLANNING •...
- Page 3 PLACE THE TOOL ON THE DOOR FOR SURFACE PREPS 1. Once the door has been marked on only one side, use the sighting window and position the RiteThru over the mark. 2. Hand tighten the drill bushing screw on the other side of the door.
- Page 4 • Once all holes have been transferred, go back to the side that was originally marked. Use the 3/16” pilot bit to drill your pilot holes. • These can be expanded to the diameter that is needed for your application. Drill the hole halfway on one side then finish the thru hole from the other side.
- Page 5 ALIGNING THE TOOL TO HIT THE TARGET • Once the point of entry for the raceway has been determined, use the body of the RiteThru to aim the extended drill bit at the termination point of the raceway. • Hand tighten the back screw only, closest to the hindge edge of the door.
- Page 6 RECOMMENDATIONS FOR DRILLING • When using a multi-piece drill bit, your drill motor should only be connected to the end section of the drill bit, this section is easily identified by it’s blunt end. It also has a small hole drilled through. Do not chuck the drill to the threaded sections of the multi-piece drill bit.
-
Page 7: Storage And Cleaning
Before storing them away, lightly oil the drill sections to prevent corrosion. 2101 John C. Watts Dr. • Nicholasville, Ky 40356 800-654-0637 • 859-885-6041 • www.lockmasters.com RT1INST Copyright © Lockmasters, Inc. 2/14...