LG DLEX89 0 Series Owner's Manual page 28

28 INSTALLATION
How to Connect the Water Inlet
Hoses
1
Check the fittings and seals. Inspect the
threaded fitting on each hose and make sure
there is a rubber seal
of each hose to prevent leaking.
2
Check the type of installation and connect the
hose to the faucet. Connect all water supply
hoses tightly by hand and then tighten
another 2/3 turn with pliers.
• Type 1 : WITHOUT WASHER (The dryer does
not share the faucet with the washing
machine.)
1) Connect the straight end of the long
hose to the cold water faucet.
b
• Type 2 : WITH WASHER (The dryer shares
the faucet with the washing machine.)
1) Shut off the cold water tap and remove
the washer inlet hose.
2) Connect the short hose
connector
d
seals.
3) Connect the other end of the short hose
to the cold water faucet.
c
4) Connect the long dryer hose
side of the Y-connector
in place in both ends
a
to the Y-
c
using one of the rubber
to one
b
. Connect the
d
washer hose to the washer and the
other side of the Y-connector
NOTE
• Before connecting the water line to the dryer,
flush several gallons of water into a drain or
bucket. This will help prevent foreign particles
such as sand and scale from clogging the dryer
inlet valve.
3
Connect the long dryer hose
inlet valve tightly by hand and then tighten
another 2/3 turn with pliers.
4
Turn on the cold water faucet.
5
Check all hoses and Y-connectors (if used) for
leaks.
.
d
to the dryer
b