JUNO T275L Installation Instructions

INSTRUCTIONS FOR T275L LENS REPLACEMENT

SAVE THESE INSTRUCTIONS
Step 1. Remove the T275L fixture from the trac
and place it face up as shown in (Figure 1).
To remove, rotate the lens retaining ring
assembly counterclockwise.
Step 2. Remove the reflector first. Then carefully
remove the original lens. Note the position and
orientation of the part number tab and the
alignment tab on the original lens as shown in
(Figure 2).
Step 3. Replace with the accessory lens as
shown in (Figure 3). Install the lens in the
following method:
- Match the part number tab with the larger slot
(Detail A) on the lens retaining ring.
- Match the alignment tab with the smaller slot
(Detail B) on the lens retaining ring.
DO NOT TOUCH EITHER FLAT SURFACE
OF THE LENS AS SCRATCHES AND
FINGERPRINTS MAY ALTER ITS
PERFORMANCE.
Step 4. To confirm the lens is installed correctly,
the part number should be backward when
looking from inside of the ring as shown in
(Detail A).
Step 5. Replace the reflector over the lens
onto the retaining ring until it clicks into
place on all three spring clips as shown in
(Figure 3). Replace the lens retaining ring
assembly by rotating it clockwise until it clicks
into place within the fixture.
Detail B
Spring Clips (3)
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Lens Retaining Ring
Assembly
Alignment Tab
See Detail B
See Detail A
Figure 3
Rev 3/17 P3746
To Remove
Figure 1
Reflector
Lens
Part Number Tab
Figure 2
Detail A
1 of 2