Omega OBO650X2 Instruction Manual page 7

Installation Instructions
•
Check that the power rating of the mains supply and of the sockets are suitable for the maximum
power of the appliance as indicated on the specification plate.
•
Plug should be accessible after installation. Fit the plug into a socket fitted with a third contact which
corresponds with the earth connection. This should be properly connected.
•
If the appliance just fitted with supply leads but does not come already fitted with a plug, then
permanently connect to fixed wiring as follow:
1- The "yellow/green" earth wire, which must be connected to terminal, has to be about 10mm
longer than the other wires; the "blue" neutral wire has to be connected to the terminal marked
with letter N.
2- "Black, brown, red" live wires have to be connected to terminal L. Mains connection can also be
made by fitting a double pole switch with a minimum gap between the contacts of 3mm,
proportionate to the load and complying with the regulations in force.
•
The yellow/green earth wire should not be controlled by the switch.
•
The plug or a double pole switch used for mains supply connection should be easy to get at, once
the appliance is in position.
•
The electrical safety of the appliance can only be guaranteed when it has been correctly connected
to an efficient earthed power supply, as laid down in the regulations for electrical safety.
•
The manufacturer cannot be held responsible for any damage to persons or objects due to lack an
earth connection.
IMPORTANT:
Position the mains supply cable so that it is never subjected to a temperature which is more than 50℃
above ambient temperature.
The appliances are supplied with installation kits and can be installed in a worktop with the appropriate
dimensions. The installation and dimensions for hob and oven are shown in the below figures:
A (mm) 557
B (mm) 550
C (mm) 595
D (mm) 575
E (mm) 576
Min/Max F (mm) 560/580
Min G (mm) 555
Min H/I (mm) 600/590
Min J/K (mm) 5/10
4