Advertisement
NOVA Defender Gate™ 10 & 20 Installation Manual
INSTALLATION: PART TWO
Installing the Gate.
TOOLS NEEDED:
• Hammer Drill
• Level
• 3/4" Wrench or Socket Wrench
Although it is possible for one person to install the gate, we recommend using a
forklift or an additional helper while lifting or carrying the gate.
1. Remove the zip tie that holds the thrust washer to the bollard. Keep the washer in
place so that it remains over the hole for the pivot pin.
2. With the GATE still folded, insert the pivot pins into the HINGE BOLLARD holes.
The handles must be on top and the 3M® striped reflective tape must be facing
the dock's interior. Move the GATE slightly back and forth until the GATE is firmly
seated.
3. Insert the cotter pins into the two pivot pins on the GATE.
4. Open gate and check leveling at multiple points.
5. Close the gate and latch. A slight leveling adjustment may be necessary to assure
clearance between latch housing and latch bollard.
Defender Gate™ installation is complete and the safety barrier system is now ready
to use.
5
Manual No. NDG-3041 - Rev. December 2021
Advertisement
