WICKED AUDIO EMBR Quick Manual

English
EMBR
Turning Earbuds On/O
Power On
Removing earbuds from the case automatically
turns on the earbuds and starts the syncing
process to one another.
or
:03 :03
L R
Power On (outside of case)
When outside the charging case and powered o ,
long press both earbuds for 3-5 seconds
(Red/Blue LED will flash) to turn them on.
Functions
1
L / R
Pause / Play Next Track
Single Press Double Press
(Left or Right Earbud) (Right Earbud)
:02 :02
R
Volume Up Volume Down
Long Press Long Press
(Right Earbud) (Left Earbud)
PRECAUTIONS
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING
DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.
Over exposure to excessive sound levels can damage your ears resulting in permanent
noise-induced hearing loss (NIHL). Please use the following guidelines established by the
Occupational Safety Health Administration (OSHA) on maximum time exposure to
sound pressure levels before hearing damage occurs.
SAFE USE & HAZARD WARNINGS
90 dB SPL at 8 hours, 95 dB SPL at 4 hours, 100 dB SPL at 2 hours, 105 dB SPL at 1 hours,
110 dB SPL at 30 min, 115 dB SPL at 15 min, 120 dB SPL: Avoid as damage may occur
MODEL #: WI-TW505X
IC: 20526-WITW505X
LIMITED ONE-YEAR WARRANTY
Keep your receipt to obtain warranty service. Go to
www.wickedaudio.com for more details.
Developed in Utah, U.S.A.
Made in China
Power O
Placing the earbuds back into the charging case
will automatically power them down.
or
:04
L
Power O (outside of case)
Long press left and right earbud for 4 seconds to
turn o earbuds without putting them in the
case.
2 2
3
R L
Previous Track Enter / Exit
Double Press Voice Assistant
(Left Earbud) Triple Click
(Left or Right Earbud)
:02
1
L / R
L
Answer Call/Hang up Call Reject Incoming Call
Single Press Long Press 2 Seconds
(Left or Right Earbud) (Left or Right Earbud)
IMPORTANT SAFETY INSTRUCTION
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings
4 Follow all instructions.
Attention should be drawn to the environmental aspects of battery disposal;The use of
apparatus in moderate climates
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference that
may cause undesired operation of the device.
In the Box
Charging Case
Charging
Charging the Charging Case
Using the Micro-USB charging cable, plug into a
power source. While charging the charging case
LEDs will flash white.
Once fully charged, the 4 LEDs will be solid white.
:04
R
LEDs
Charging Case Lights
when Charging Case:
Flashing White LEDs
4 LEDs Solid White
L / R
Troubleshooting
L / R
Limitation of Liability Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.The
device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
In no event, under any cause of action of theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential,
special, exemplary or punitive damages, of any and all nature whatsoever, arising out of use of or inability to use a product. This includes without limitation, property damage, loss of
value of the product or any third party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages
that one may encounter. Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics
devices or other personal property that are contained in inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held
devices, or any loss of data contained on the foreign device. Notwithstanding any damages that you might incur for general damages in contract, tort (including negligence) or
otherwise), the entire aggregate liability of Wicked Audio and any of its distributors and/or suppliers shall be limited to the amount actually paid by you for the Wicked Audio product
giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not
apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.
Left Earbud
USB to Micro-USB
Charging Cable
Charging the Earbuds
Place earbuds in charging case to charge earbuds.
They will turn o and automatically begin
charging. While charging the earbuds, the
charging case LEDs will be a solid white. When
the earbuds are fully charged the charging case
LEDs will shut o .
Tip: Earbuds will announce "low charge" when
they are at 10% battery life.
Charging Case Lights
when Charging Earbuds:
Case is Charging Solid White LEDs
Full Charge Reached LEDs shut o
Reset
Only one earbud connecting to device at a time?
1. From your device's Bluetooth menu, delete "Wicked Embr" pairing name
2. Place earbuds in charging case.
3. Remove one earbud from charging case.
4. Press earbud button 4 times and return to charging case.
5. Remove the other earbud from charging case.
6. Press earbud button 4 times and return to charging case.
7. Remove both earbuds from charging case.
8. Earbuds will start the syncing process to each other.
9. Once synced you can then locate "Wicked Embr" in your Bluetooth settings to
pair to your device.
Right Earbud
Cushions
In the Box
Embr TWS Earbuds
Charging Case
USB to Micro-USB Charging Cable
3 Sizes of Cushions
Instruction Booklet
Earbuds are Charging
Earbuds fully charged