Subscribe to Our Youtube Channel
Summary of Contents for MedRx UltraVac+
- Page 1 O P E R A T I N G I N S T R U C T I O N S Hearing Instrument Restoration System www.medrx-usa.com...
- Page 2 As with all of our products, MedRx is pleased to provide the top notch service and support that you have come to expect. Our associates constantly strive to see that every effort is put forth in satisfying your needs and requests.
-
Page 4: Table Of Contents
Care and Maintenance ........9 Troubleshooting Guide ........12 Limited Warranty ..........13 Specifications ..........14 www.medrx-usa.com 1200 Starkey Rd. #105, Largo FL 33771 Toll Free: (888) 392-1234 • (727) 584-9600 Fax: (727) 584-9602 • Email: medrx@medrx-usa.com UltraVac+ Manual • UVP-I-MULVAC-1 Effective 12-09-16... -
Page 5: Controls And Components
CONTROLS AND COMPONENTS Your UltraVac+ System Includes: • UltraVac+ Base Unit • Pressure Wand with Hose • Vacuum Wand with Hose and Filter • Drying Chamber Cup • 6 Vacuum Wand Tips • Operator Instruction Manual • Cleaning Tool Kit See back cover for details The cord attachment and fuse are located on the rear panel of the unit. -
Page 6: Recommended Procedure
The system is powered by the switch on the back of the unit. The operation of each function is explained later in this manual. We recommend the system be turned off when not in use for extended periods of time (especially overnight). The function switch on the front panel is labeled to easily indicate which feature is being used. -
Page 7: Drying Chamber
DRYING CHAMBER To use the Drying Chamber, place the hearing aid (including earmold if BTE) on the pad and cover it with the vacuum cup. You can place two ITE’s or one BTE with mold in the chamber at a time. -
Page 8: Pressure Wand
drying chamber was in use when moving the switch to the WAND setting, it will be necessary to press START again to restart the pump. Choose the appropriate vacuum tip which will allow to insert into tube openings, vents compartments. Care should taken so the tubes or... - Page 9 Cleaning - To keep your UltraVac+ looking brand new, wipe the cabinet and control panel with a soft cloth. Stubborn stains may be removed by using a cloth moistened with water and mild detergent. Do not allow debris or fluid to enter the Drying Chamber air inlet port.
- Page 10 reapply the cleaning solution and allow surfaces to remain wet for five (5) minutes to achieve the Bactericidal, General Virucide, Fungicidal and Tuberculocidal claim. 6. Soiled rags should be placed in a bag for laundering. Disposable cloths should be disposed as regular waste in garbage bags.
-
Page 11: Troubleshooting Guide
TROUBLESHOOTING GUIDE SYMPTOM REMEDY Won’t come on. -Check fuse located on rear panel. -Call for service. -Check that the Drying Chamber switch is in the Vacuum Wand Vacuum Wand not setting. working. -Check to make sure hose is connected properly in panel. -Check to make sure filter is properly attached and not blocked. -
Page 12: Limited Warranty
MedRx, Inc is not responsible for problems resulting from installation of unapproved software or hardware. In the event of unapproved software or hardware installed on the system causing a conflict, MedRx will service the product for a fee to be determined at the time of service. -
Page 13: Specifications
SPECIFICATIONS Power Requirements 100-240 VAC, 50-60 Hz Power Consumption <100 watts Fuse 110 Volt 1.25 amp SB 5x20mm 220 Volt 2.50 amp SB 5x20mm Operating Temperature 0° to 50° C (32° to 120° F) Weight Approx. 8.5 lbs. <5 kg Dimensions (approx.) 10.5”... - Page 14 The UltraVac System Includes UtraVac Base Unit Pressure Wand with Hose Vacuum Wand with Hose & Filter 6 Vacuum Wand Tips & Drying Chamber Filter Instruction Manual Cleaning Tool Kit Drying Chamber...
Need help?
Do you have a question about the UltraVac+ and is the answer not in the manual?
Questions and answers