Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for STROMBERG e-FIRE
Summary of Contents for STROMBERG e-FIRE
- Page 1 If you need further information or assistance, please contact your Stromberg dealer, or e-mail us direct at: tech stromberg-97.com or log on to our Tech Center at: stromberg-97.com SSP 9018V1 STROMBERG e-FIRE OWNER’S MANUAL 8BA MODELS Made by Stromberg in England...
- Page 2 There is help available at the Stromberg Tech WARNING: but is not limited to, spark plugs and plug wires, battery, This e-FIRE distributor (12v negative or 6v positive battery cables, generator or alternator, starter, starter Center: www.stromberg-97.com. And you can ground) should be used with a 1.5 Ohm (Ω) coil.
- Page 3 2. REMOVE EXISTING DISTRIBUTOR distributor into the 8BA timing cover engaging cause the e-FIRE ignition module to fail and void USE E-FIRE HIGH PERFORMANCE your warranty. the drive gear into the camshaft gear so that SPARK PLUG WIRES.
- Page 4 (See A). The distributor turns clockwise. 12 volt negative ground e-FIRE distributors are compatible with most Capacitor Discharge Ignition 12 volt negative ground e-FIRE distributors have units. Follow the manufacturer’s instructions, red and black low tension wires.
- Page 5 If running improves, this usually quickly. If you hear detonation, stop the engine All of the e-FIRE steel internal parts are zinc adjustment of the total advance, for most indicates low voltage to the module, often caused immediately and retard the timing.
- Page 6 TO, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL Stromberg is the sole and final judge of whether a 3. If the product needs replacement, we will provide a STROMBERG OR ITS AGENTS, EMPLOYEES, product is covered by the warranty.
Need help?
Do you have a question about the e-FIRE and is the answer not in the manual?
Questions and answers