Advertisement
INSTALLATION GUIDE FOR
ARV13/YRV13 LED with SHCAB
SAFETY PRECAUTIONS
WARNING - Risk of fire or electric shock. Basic safety precautions should always be
followed when using electrical equipment.
WARNING - This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
WARNING - Disconnect power to all circuits before wiring fixture.
WARNING - Install in accordance with all national, state, and local codes.
WARNING - The main (white LED) circuit and the auxiliary circuit (Nightlight) are to
be wired to separate circuits that can't be powered on simultaneously.
WARNING - Do not connect to an ungrounded supply.
WARNING - Read all fixture markings and labels to ensure correct installation of
fixture.
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page 1 of 4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Luminaire led ARV13
Summary of Contents for Luminaire led ARV13
- Page 1 INSTALLATION GUIDE FOR ARV13/YRV13 LED with SHCAB SAFETY PRECAUTIONS WARNING - Risk of fire or electric shock. Basic safety precautions should always be followed when using electrical equipment. WARNING - This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Page 2 INSTALLATION GUIDE FOR ARV13/YRV13 LED with SHCAB CAN ICES-005 (A) / NMB-005 (A) FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 3 INSTALLATION GUIDE FOR ARV13/YRV13 LED with SHCAB Unlock Lock Lock Unlock Set Screw Set Screw Set Screw Ring / Eyelid Ring/ Eyelid Ring / Eyelid INSTALLATION PROCEDURE WARNING - The main (white LED) circuit and the auxiliary circuit (Nightlight) are to be wired to separate circuits that can’t be powered on simultaneously.
- Page 4 INSTALLATION GUIDE FOR ARV13/YRV13 LED with SHCAB 12. It is recommended to align the screw receiver slots to the 3 O’clock position for wall mounting. 13. Pull the wire harness through the Base Plate. 14. Re-attached the Base Plate using the ¼” – 20 screws.
Need help?
Do you have a question about the ARV13 and is the answer not in the manual?
Questions and answers