Advertisement
Control Boxes
for Hios Electric Screwdrivers
CB-105
SUB
Operation Manual
( February 2008 )
Before using your equipment, please read this operation
manual and that of the Hios Electric Screwdriver and power
supply. Carefully follow the instructions and heed all
warnings to insure correct operation and safety.
The CB-105 Control Box can be used with all models in the CL
α
series, SS series and
series of Hios electric screwdrivers.
Please use them in combination with MC-70L.
Installation Warnings
1. Following the instructions in the operation manual of the power
supply you are using. Take care to pair the screwdriver with
an appropriate power supply.
2. Be sure to ground CB-105.
3. Connect the positively charged red cord and the negatively
charged black cord into sockets that have corresponding
colors.
4. When using a cord not specifically designed for the screwdriver,
be careful not to insert the plus and minus plugs into the wrong
sockets. Also, be sure to use an appropriate power supply.
Don't use cords intended for AC electrical outlets or other
connectors that have the possibility of causing problems.
5. After connecting the electrical cord and the screwdriver's
connecting cord, don't unnecessarily tug on them, put them
under heavy objects or allow them to rub against sharp edges.
6. When plugging and unplugging the screwdriver's connecting
cord and the electrical cord, firmly grasp the plug portion of
the cord.
Usage Warnings
If there is a malfunction, do NOT open the machine's case
and attempt to do repairs on your own! Send the machine in
for repairs.
When the machine is not used, turn off the main switch.
Be sure to ground the machine.
Controls and terminals
Terminal (male)
Black
Red
Ground
08A
Output connectors
(for connection to screwdriver connectors)
Connection Instructions for CB-105
When the power supply MC-70L is connected to various
screwdrivers, there is an upper limit to the number of screw-
drivers that can be simultaneously supported by CB-105:
• In the case of CL-2000, 3000, 4000, SS-3000 and 4000
• In the case of α-4500 and 5000
• In the case of CL-6000, 6500, 7000, SS-6500 and 7000
• In the case of α-6500
Allow for adequate spacing when connecting main power wires
from assembly line power supplies.
(1) Connect the female terminals of branch wires to the male
terminals of CB-105 (SUB).
Caution: Be sure to match colors for these connections.
(2) Connect the electric screwdriver cord to the CB-105 output
connector.
Connection to MC-70L
Red
Red
MC-70L
Sub-cord (input)
SUB
Attachment plates (2 pieces)
a maximum of 20
a maximum of 10
a maximum of 10
a maximum of 5
Main wires
Black
Branch wires
Black
SUB
SUB
CB-105
SUB
70(W) × 42(D) × 100(H)
Dimensions (mm)
Sub-cord length (m)
2
Ground-cord length (m)
2
Weight (g)
240
Approx.
(The above dimensions do not include
projecting portions.)
Attachment plates
CB-105 comes with two attachment plates. Please attach one or
both, as attachment conditions require, before using. Removing
the attachment plates by pushing upward with the thumbs as shown
in the diagram.
Attaching
Attachment the CB-105
When using CB-105, be sure it is mounted on a level, stable
platform. Be sure it does not interfere with power cords, as shown
in the diagram.
Removing
HIOS inc.,
tel: 81-47-392-2001
fax:81-47-392-7773
Advertisement
