LX JS12 Original Instruction TABLE OF CONTENTS Intended use General safety information Product safety information Symbols Technical data Description of product Operation Cleaning Storage Disposal Troubleshooting Declaration of Conformity...
Page 3
Worklight Warning light Warning light flashing USB1 USB2 Worklight Worklight flashing DC 12V OUT JUMP START INPUT...
INTENDED USE PRODUCT SAFETY INFORMATION - Never look into the LED beam. There is a risk of dazzling This product is exclusively intended for the use as a mobile light beamer for limited time in dry indoor and outdoor areas as a helper in starting motor yourself and causing damage to the retina of the eye.
Page 5
PRODUCT SAFETY INFORMATION PRODUCT SAFETY INFORMATION Danger of Lithium batteries Therefore, never use any charger other than the one Lithium batteries have high energy density and provide supplied with the device. Do not use for charging dry high performance in their application Therefore, all safety cells that are commonly used in household appliances.
Symbol meaning TECHNICAL DATA This page depicts and describes safety symbols that may appear on this product. Read, understand and follow all Model LX JS12 instructions on the machine before attempting to assemble Degree of protection IP54 and operate. 3x4000mAh, 11.1V DC Lithium Battery capacity 41.07Wh...
DESCRIPTION OF PRODUCT OPERATION Parts description (Fig. A) Charging the device The supplied battery is only partially charged. Before initial use, fully charge 1. Hanging loop battery. 2. LED working light After the first charge, we recommend fully discharging the battery and the 3.
OPERATION OPERATION The charger was designed to charge battery pack between 0 °C and 50 °C. If Use as a usb power source(Fig. D) the battery pack is too cold or too hot, the charger will not charge. Allow the This device can be used to power or recharge a wide range of small electronic battery to warm up or cool down.
Page 9
OPERATION OPERATION 4. Connect the SMART Cable connector to the device. The connector is NOTE: The device may not be able to help you in the first attempt to start under the cover on the side of the device. Make sure the cable is securely the vehicle in very cold weather.
CLEANING TROUBLESHOOTING Problem Failure Caution! Protect the product from direct contact with water, and The device was recharged, the make sure that water doesn't get the opportunity to get in. charging LED signalled but there was Defective charger no change in status even after several •...
Page 11
Declare that the product: Declare that the product: Description: Jump start Description: Jump start Model No. LX JS12 / SHSD-01B Model No. LX JS12 / SHSD-01B Function: jump start, work light, power bank Function: jump start, work light, power bank...
59 bis Rue du Mûrier 37540 Saint Cyr Sur Loire, France Declare that the product: Description: Jump start Model No. LX JS12 / SHSD-01B Function: jump start, work light, power bank Complies with the essential health and safety requirements of the following directives:...