Page 1
Wind Sensors INDUSTRY Modbus INDUSTRY Modbus · Your Advantages Possible Applications The INDUSTRY Modbus wind sensors are very economical The Modbus RTU interface simplifies installation of the sen- to purchase. The sensors also impress with their high ac- sors and integration into networks.
Autoconfiguration Technical data Disposal LAMBRECHT meteo GmbH is listed and registered at the Stiftung Elektro-Altgeräte Register ear under: WEEE-Reg.-No. DE 45445814 In the category of monitoring and control instruments, device type: “Monitoring and control instruments for exclusively com- mercial use”.
Manual Wind Sensors INDUSTRY Modbus Initial operation II. Mast or pipe mounting Make sure the device is easily accessible so that you Wind can be represented by a vector quantity. For a complete can set up the north direction for the wind direction description of the wind it is necessary to specify its speed and sensor and perform any maintenance work.
Manual Wind Sensors INDUSTRY Modbus When installing the connecting cables, make sure Please note that the cable on the data processing side is pro- not to excessively shorten the cable leading to the tected against moisture, e.g. by using suitable cable glands.
This manual covers the general Modbus specification common to all Modbus sensors from LAMBRECHT meteo. The manual allows easy operation of all LAMBRECHT meteo Modbus sensors. Some sensors of the Modbus family offer additional regis- ters and functions, which are described in separate documents via the registers and functions described here. The registers and functions described in this manual are sufficient for general operation of Modbus sensors in a weather station or PLC.
Manual Wind Sensors INDUSTRY Modbus Instantaneous values / realtime values (Input Register) The following measured values are provided: Register address Parameter name Unit Divisor Quantity of registers Access type 30001 Wind speed Read only 30201 Wind direction ° Read only...
OK:097E 9.9 Autoconfiguration All Lambrecht Modbus sensors offer the experienced user the possibility to implement an auto-configuration in his Modbus master based on additional information stored in the sensor. The necessary information can be found in the document “Lambrecht_Modbus_Autoconfiguration”. (14567/14577) INDUSTRY Modbus...
Included in delivery: 1 sensor (without cable) For connection to: Lambrecht meteo data processing systems · power supplies · user specific evaluation systems (not included in delivery) Accessory: Id-No. 32.14567.060000 · sensor cable with M12, 4 pin female connector, length: 12 m...
Need help?
Do you have a question about the INDUSTRY Modbus and is the answer not in the manual?
Questions and answers