Download
Share
Print this page
Velleman VTSDIR User Manual
  1. Manuals
  2. Brands
  3. Velleman Manuals
  4. Rework stations
  5. VTSDIR
  6. User manual
Velleman VTSDIR User Manual

Velleman VTSDIR User Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
V
VTSD
DIR
IN
NFRA-RE
ED SMD &
& BGA RE E WORK S
STATION N
 
US
SER MAN
UAL
3

Advertisement

loading
Need help?

Need help?

Do you have a question about the VTSDIR and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Velleman VTSDIR

Summary of Contents for Velleman VTSDIR

  • Page 1 VTSD NFRA-RE ED SMD & & BGA RE E WORK S STATION N   SER MAN...
  • Page 2 VTSDIR Main station front panel Main station rear panel Figure 21.03.2011 ©Velleman nv...
  • Page 3 If in d doubt, cont tact your lo ocal waste disposal au uthorities. ank you for buying the V VTSDIR! Ple ease read th e manual tho oroughly bef fore bringing g this device into service. e device was s damaged in...
  • Page 4 VTSDIR • The system m can prod uce a lot of f heat. Do n not allow the e IR spot from m the IR ha nd tool or IR R from the P pre-heater, to contact e exposed skin n as burning may occur.

  • Page 5: Operation

    VTSDIR 6. Setup Refer to the illustrations on page 2 of this manual. Note: never unplug any connection during operation. • The equipment must be sited on a firm surface at least 1.2M x 0.75M and at a height to suit the operator.
  • Page 6 VTSDIR Preparation The proced ure for prep aring to rew work SMT/BG GA componen nts is as follo ows: • Switch h on and war rm up. • Set ‘co ontrol setting gs’ required for PCB/com mponent • Sort to ools and flux xes required.

  • Page 7: Technical Specifications

    ±7kg Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulted from (incorrect) use of this device. The information in this manual is subject to change without prior notice.
  • Page 8 VTSDIR Appendix 1 Remove screws [X], remove metal bar [Y] and remove plastic tubes [Z]. 21.03.2011 ©Velleman nv...
  • Page 9 VTSDIR Place the metal grid and secure it with the two screws [X]. 21.03.2011 ©Velleman nv...
  • Page 10 VTSDIR Appendix 2 21.03.2011 ©Velleman nv...
  • Page 11 VTSDIR 21.03.2011 ©Velleman nv...
  • Page 12 Velleman® Service and Quality Warranty Velleman® has over 35 years of experience in the electronics world and distributes its products in more than 85 countries. All our products fulfil strict quality requirements and legal stipulations in the EU. In order to ensure the quality, our...