Printed Circuit Board; Parts Location And Replacement Parts List - Panasonic RC-Q500 Service Manual

- Ground the soldering iron.
- Do not touch the pins of IC, LSI or VLSI with fingers directly.

7. Printed Circuit Board

(This printed circuit board diagram may be modified at any time with the development of new
technology.)

8. Parts Location and Replacement Parts List

Note:
- Important safety notice:
Components identified by
important for safety.
Furthermore, special parts which have purpose of fire-retardant
(resistors), high-quality sound (capacitors), low-noise (resistors),
etc. are used.
When replacing any of these components, be sure to use only
manufacturer's specified parts shown in the parts list.
- The parenthesized indications in the Remarks columns specify the
areas or colour. (Refer to the cover page for area or colour)
Parts without these indications can be used for all areas.
- Capacitor values are in microfarads (
otherwise, P=Pico-farads (pF), F=Farads.
- Resistance value are in ohms, unless specified otherwise, 1K=
1,000 (OHM).
- The marking (RTL) indicates that the Retention Time is limited for
this item. After the discontinuation of this assembly in production,
the item will continue to be available for a specific period of time.
The retention period of availability is dependant on the type of
assembly, and in accordance with the laws governing part and
product retention. After the end of this period, the assembly will
no longer be available.
- [M] Indicates in the Remarks columns indicates parts supplied by
MESA.
- The "(SF)" mark denotes the standard part.
- Reference for O/I book languages are as follows:
mark have special characteristics
F) unless specified