Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Centurion FLUX 11
Summary of Contents for Centurion FLUX 11
- Page 1 FLUX 11 Pocket installation manual SENSITIVE INDUCTIVE LOOP DECTOR...
-
Page 2: Safety Instructions
(or safety) loop using a single loop detector base. In addition, the FLUX 11 is available in both a low-voltage, energy efficient 12V DC variant as well as a powerful 230V AC model, making it an extremely versatile access control solution and eliminating the need for expensive transformers or time-consuming rewiring. -
Page 3: Product Identification
10. Anything not expressly specified in these instructions is not permitted. 2. Product identification FLUX 11 housing 11 pin connector Sensitivity level indicator LEDs Diagnostic LEDs Bootloader header... -
Page 4: Technical Specifications
3. Technical specifications Supply voltage: 12V DC Model 10 - 40V DC 7 - 28V AC 230VAC Model 220-240V AC +-10% 50Hz Standby current: 12V DC Model 10mA 230VAC model <10mA Output relay rating: 1A @ 125V AC 4ms @ 100kHz loop frequency Detection time: 10ms @ 40kHz loop frequency Indicators:... - Page 5 The frequency of the loop is determined by the inductance of the loop and the frequency switch Frequency setting. If the frequency switch is on, the frequency Selection is reduced by approximately 25%. It may be Switch necessary to change the frequency to prevent cross- talk between adjacent loops.
-
Page 6: Led Indicators
Undetect 6. Tips for a successful loop installation The FLUX 11 should be installed in a weatherproof location, such as the inside of a traffic barrier, as close to the loop as possible. The loop and feeder should be constructed from XLPE (cross- linked polyethylene) insulated multi-stranded copper wire with a minimum cross-sectional area of 1.5mm . - Page 7 The feeder should be twisted at a rate of at least 20 turns per metre to improve reliability (Remember that twisting the feeder will shorten its length, so ensure a long enough feeder wire is used). Feeders which may pick up electrical noise should use screened cable, with the screen earthed at the detector.
-
Page 8: Mounting Instructions
Corner stress relief 7. Mounting instructions The housing of the FLUX 11 is not weatherproof, and it should not be mounted externally. Simply insert the FLUX 11 into the 11 pin base of the access control device. 8. Electrical setup 1. -
Page 9: Commissioning The System
Configure the desired operational settings using the Dipswitches (open the access flap to access the Dipswitches). Test the FLUX 11 using a metallic object, or a vehicle. 10. Diagnostics Possible cause... - Page 10 Sharecall 0860-CENTURION (0860 236 887) Head Office: +27 11 699 2400 Sharecall Technical Support 0861 003 123 or +27 11 699 2481 from 07h00 to 18h00 (GMT+2) Sharecall numbers applicable when dialed from within South Africa only) 0.07.A.0028_22072013 www.centsys.com...
Need help?
Do you have a question about the FLUX 11 and is the answer not in the manual?
Questions and answers