Page 11
WARNING This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the To prevent fire or shock hazard, do not literature accompanying the appliance. expose the unit to rain or moisture. WARNING: THIS WARNING IS APPLICABLE FOR USA To avoid electrical shock, do not open the ONLY.
Page 13
Table of Contents Precautions ..................4 (E) Overview ....................4 (E) Preparations ..................5 (E) Required Software ................5 (E) Selecting a Computer ..............5 (E) Before Installing the Boards ............5 (E) DIP Switch Settings................ 6 (E) Installing the Boards ................7 (E) Location and Function of Parts ............
Overview • IDC connectors The BSS-100 SMS Standard Package consists of this manual and the items listed below. These items are to Used to connect IDCs to the IDC interface board. be installed in the host computer, which will be referred to as the “computer”...
To use the BSS-100 involves installing a full-size AT- bus board (IDC interface board) and a half-size AT- If the computer is not a Sony QL-50, refer to the bus board (board with IDC connectors) in the documentation supplied with the computer or with computer.
Preparations DIP Switch Settings DIP switch SW1 on the IDC interface board controls the I/O address for the board. For the positions of the DIP switch, see the section “Installing the Boards” (page 7(E)). SW1 settings Switch Function Factory Notes number default I/O address...
Installing the Boards Precautions Use the following procedure to install the component boards of the BSS-100 in the computer (Sony QL-50). • Do not modify the printed circuit boards If your computer is other than the Sony QL-50, install Modifying the printed circuit boards can cause fires.
Page 18
Installing the Boards Make sure the junction posts and DIP switches SW1 on the IDC interface board are set as shown in the figure on the right. Notes • If the I/O address settings on the IDC interface board IDC interface board have been changed, the settings of DIP switches 1 and 2 of SW1 will not be as shown in the figure.
Location and Function of Parts IDC connectors (D-sub 9-pin x 2) RS-422A compatible output connectors. Connect these connectors to the IDC (Intelligent Device Controller). Specifications Environment Operating temperature: 10 ºC to 35 ºC (50 ˚F to 95 ˚F ) Operating humidity: 30% to 70% (Condensation not allowed) Storage temperature: 0 ºC to 60 ºC (32 ˚F to 140 ˚F ) Storage humidity: 20% to 90% (Condensation not allowed) Dimensions...
Page 21
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any...