Subscribe to Our Youtube Channel
Summary of Contents for TIE AMBITECH BRAKE-PAK
- Page 1 Form 1288 Brake Pak Installation/Setup Instructions 44810 Vic Wertz Drive, Clinton Township, MI 48036 888-621-6221 www.ambitechbrakes.com p. 1...
- Page 2 Ambi-Tech Brake Pak – Installation/Setup Instructions APPLICATION The BRAKE-PAK Electronic Motor Control is designed for use with switch controlled single phase AC induction motors. (Use SHORT-STOP for motors with magnetic starters). It will operate with virtually all single phase motors that do not have brushes. Since braking action is achieved by the use of direct current, it will not brake a DC or universal motor.
- Page 3 B. Chassis Unit 1. Turn power OFF before proceeding with any wiring. 2. Turn the existing machine operating switch to the OFF position. 3. Mount the unit securely in any position. 4. Refer to Figure B.1 5. Connect the black wire from the BRAKE-PAK to the + power wire from line in. 6.
- Page 4 UNIT OPERATION The BRAKE-PAK ON-OFF control switch is located on the right side of the enclosure. Set the switch to the “ON” (closed) position to start the machine. Set the switch to the “OFF” (open) position to initiate the automatic brake cycle. Closing the switch while an automatic brake cycle is in progress will terminate the brake and start the machine.
- Page 5 Page 5...
Need help?
Do you have a question about the AMBITECH BRAKE-PAK and is the answer not in the manual?
Questions and answers