Front Panel Controls; Front View - Hitachi 42HDF52 Operating Manual

FRONT PANEL CONTROLS

①
REMOTE CONTROL sensor
Point your remote at this area when selecting channels, adjusting volume, etc.
②
POWER light indicator
To turn the PDP TV ON, press the main power button located on the BACK left side of the TV. A red stand-by indicator lamp
located on the lower right corner of the front bezel will illuminate. The PDP TV is now ready for remote on/off operation.
Indicating Lamp
Off
Lights Red
Lights Orange
Lights Green
③
POWER button
This power button is for power on the plasma television or change to standby mode.
④
CHANNEL selector
Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as the
cursor down (▼) and up (▲) buttons when in MENU mode.
⑤
VOLUME level
Press these buttons to adjust the sound level. The volume level will be displayed on the TV screen. These buttons also serve as the
cursor left ( ) and right ( ) buttons when in MENU mode.
⑥
INPUT/EXIT button
Press this button to select the desired input: NTSC, DTV, Composite-VIDEO, S-VIDEO, YC
This button also serves as the EXIT button when in MENU mode.
⑦
MENU/SELECT button
This button allows you to enter the MENU, making it possible to set TV features to your preference without using the remote. This
button also serves as the SELECT button when in MENU mode.

FRONT VIEW

42" PLASMA TV
Power Status Operating
Off When the MAIN POWER is set OFF.
Off (Stand-by) When the MAIN POWER is set ON and the Front Key or
Remote Control POWER is OFF.
Off (Power Saving) 1. When the MAIN POWER is set ON.
2. No signal input (no sync. signal).
On When the POWER is ON.
12
C , YP P , Analog RGB or DVI source.
B R B R